Landfills of hazardous waste like radioactive rest products with low activity, or ashes from incinerated organic waste, need to have top clay liners for minimizing penetration and percolation of precipitated rain and meltwater. Temperature and dry weather vary interchangeably with wet periods making the clay desiccate and fissure, and subsequently wetted etc. Top liners are commonly made of sme...

In temperate European climates, the season of peak water demand by vegetation (summer) is out of phase with the season of greatest rainfall (winter). This results in seasonal fluctuations in soil water content and, in clay soils, associated problems of shrinking and swelling that can in turn contribute to strain-softening and progressive slope failure. This paper presents field measurements of ...

Salinomycin is polyether ionophore, commonly used in poultry industry for the prevention of coccidial infections and promotion of growth. A large amount of the administered antibiotic is excreted as parent compound, eventually reaching agricultural lands. This makes it imperative for researchers to understand the behavior of the compound in soil environment by conducting sorption-desorption stu...

Runoff, soil loss, sediment concentration, and particle size distribution of sediment eroded by runoff events were measured between 1976 and 2000 from 5 small agricultural watersheds on Vertisols at ICRISAT Center, Patancheru, India. The effects of storm size and land management system on total soil loss and size distribution of sediment during runoff are discussed. At the beginning of runoff e...

Soft clays are defined as cohesive soil whose water content is higher than its liquid limits. Thus, soil-cement mixing is adopted to improve the ground conditions by enhancing the strength and deformation characteristics of the soft clays. For the above mentioned reasons, a series of laboratory tests were carried out to study some fundamental mechanical properties of cement stabilized soft clay...

In order to study the influence of different clay contents on fractality red clay, specimens having four water were prepared. The cracking characteristics observed at 20 °C and 60 °C. Image J software was used measure calculate crack area, ratio, length width each sample. test results showed that development cracks in could be divided into three stages: generation, stabilization. particle conte...

in order to comparing geostatistics and artificial neural networks (ann) methods in predicting soil salinity and clay content this experiment was conducted in sistan region land. 121 soil samples were taken at the depth of 0-30 cm within the grid of 750 750 m and soil ec and clay percent were determined. 105 samples were used for training and 16 samples were used for test in both models. diffe...

Nylon 11 (PA11)/clay nanocomposites have been prepared by melt-blending, followed by melt-extrusion through a capillary. Transmission electron microscopy shows that the exfoliated clay morphology is dominant for low nanofiller content, while the intercalated one is prevailing for high filler loading. Melt rheological properties of PA11 nanocomposites have been studied in both linear and nonline...

[1] To understand the role of hydrated clay minerals in active fault systems, a humidity chamber connected to an X-ray diffractometer was used to determine the adsorption of water onto and/or into the crystal structure of smectite. This new type of analysis was carried out under specific temperature and humidity conditions, using powdered clay size fractions (< 2 mm) of rock samples from the Sa...

Introduction: The Mars Express OMEGA imaging spectrometer recently identified clay minerals (nontronite and montmorillonite) in several outcrops of Noachian age [1]. Clay minerals usually result from long term alteration of primary minerals by liquid water and on Earth are usually the products of weathering processes. The presence of clay minerals suggests a primary environment completely diffe...