This paper describes a 1.5-V 5 GHz I/Q down conversion mixer in a 0.18-μm CMOS process. The mixer achieves a conversion gain of 12.7 dB within 1-dB compression point (iCP1dB) of -15.83 dBm. It also achieves a double side band (DSB) NF of 13.5 dB. The mixer's IIP3 is -5.94 dBm. The mixer consumes only 5.72 mA of current from a 1.5-V power supply. Key-Words: Analog RF-CMOS, IEEE 802.11a, IEEE 802...

Chaotic mixing strategies produce high mixing rates in microfluidic channels and other applications. In prior numerical and experimental work the variance of a tracer field in a chaotic mixer has been observed to decay rapidly after an initial slower transient. We relate this to the cutoff phenomenon observed in finite Markov chains and provide numerical evidence to suggest that chaotic mixing ...

Abstract This paper describes a new switching topology of a sampling mixer for SAW-less GPS (L1 band) receivers. The GPS receiver with the new mixer achieved NF 2.5dB and good blocking performance. In an alternative implementation, the mixer is stacked under a Quadrature VCO to reuse supply current. As a result, the current consumption of the GPS receiver is 11mA from 1.8V supply while maintain...

A linearity improvement technique for a common-source transconductance stage is proposed. The proposed technique requires an additional MIM capacitor located in parallel with the intrinsic gate-source capacitor of a transistor. The origin of the linearity improvement is explained and the proposed technique is applied to a down-conversion mixer. From the simulation, the down-conversion mixer tha...

The impedance of the superconducting hot-electron bolometer mixer was measured in the range 0.2-4 GHz. A special technique relying on determination of the Sz, transmission parameter of the device was used. Many advantages of the technique (wide frequency range, in situ calibration, low test power, accuracy) are demonstrated. The estimate of the mixer bandwidth from the impedance data using the ...

To achieve high mixing efficiency in microfluidic devices, complex designs are often required. Microfluidic devices have been evaluated with light and confocal microscopy, but fluid-flow characteristics at different depths are difficult to separate from the en face images produced. By using optical coherence tomography (OCT), an imaging modality capable of imaging 3D microstructures at micromet...

In this paper, we describe the design, fabrication, and the performance of a low-noise dual-polarized quasi-optical superconductor–insulator–superconductor (SIS) mixer at 550 GHz. The mixer utilizes a novel cross-slot antenna on a hyperhemispherical substrate lens, two junction tuning circuits, niobium trilayer junctions, and an IF circuit containing a lumped element 180 hybrid. The antenna con...

The Atacama Large Millimeter Array (ALMA) requires low noise SIS receivers for frequencies from about 80 GHz to 950 GHz with a very large IF bandwidth (8 GHz SSB upper or lower sideband, 8 GHz DSB or 4 GHz dual sideband, upper and lower sideband). Since there will be a large number of antennas in the array (currently 64), additional requirements such as high reliability, low cost, and the produ...

The first step in dealing with the behavior of an engine on NG mode is the installation of a suitable gas fueling system on the engine. Two generations of gas fueling systems which were studied and installed on research engine were Mixer type and Sequential system type. The results, including performance, emissions and fuel consumption, were recorded and analyzed. The results showed that the...