Chiral MnIII (salen) complex supported on modified ZPS-PVPA (zirconium poly(styrenephenylvinylphosphonate)) and ZPS-IPPA (zirconium poly(styrene-isopropenyl phosphonate)) were prepared using –CH2Cl as a reactive surface modifier by a covalent grafting method. The supported catalysts showed higher chiral induction (ee: 72%–83%) compared with the corresponding homogeneous catalyst (ee: 54%) for a...

In this study, characterization of vanadia supported on Al-modified titania nanotubes (TiNTs) synthesized by the alkaline hydrothermal treatment of TiO2 powders has been reported. A promising catalyst for oxidative dehydrogenation (ODH) of propane was prepared via the incipient wetness impregnation method. The morphology and crystalline structure of TiNTs were characterized by transmission elec...

In this work, we present a synthesis approach for nitrogen-doped graphene-sheet-like nanostructures via the graphitization of a heteroatom polymer, in particular, polyaniline, under the catalysis of a cobalt species using multiwalled carbon nanotubes (MWNTs) as a supporting template. The graphene-rich composite catalysts (Co-N-MWNTs) exhibit substantially improved activity for oxygen reduction ...

Initial studies on aging detection of three way catalysts with a microwave cavity perturbation method were conducted. Two physico-chemical effects correlate with the aging state. At high temperatures, the resonance frequencies for oxidized catalysts (λ = 1.02) are not influenced by aging, but are significantly affected by aging in the reduced case (λ = 0.98). The catalyst aging state can theref...

Silica particles were prepared by flame spray pyrolysis (FSP) as a support for nickel catalysts. The impact of precursor feed rate (3, 5 and 7 mL/min) during FSP on the silica characteristics and the ensuing effect on catalytic performance for the carbon dioxide, or dry, reforming of methane (DRM) was probed. Increasing the precursor feed rate: (i) progressively lowered the silica surface area ...

Changes in BET surface area and morphology of Ti02 (anatase) were studied as a function of temperature and level of chlorine contamination. The objective was to study the behavior of TiO2 supports under typical catalyst preparation and reaction conditions, using adsorption, wide angle X-ray diffraction and scanning electron microscopy. Chlorinated samples had lower surface areas compared to bla...

A new strategy for preparing spatially-controlled, multi-component films consisting of molecular light absorbing chromophores and water oxidation catalysts on high surface area, mesoporous metal oxide surfaces is described. Atomic layer deposition (ALD) is used to embed a surface-bound chromophore in a thin layer of inert Al2O3, followed by catalyst binding to the new oxide surface. In a final ...

It is of great significance to design a platform with large surface area and high electrical conductivity for poorly conductive catalyst for hydrogen evolution reaction (HER), such as molybdenum sulfide (MoS x ), a promising and cost-effective nonprecious material. Here, the design and preparation of a free-standing and tunable graphene mesoporous structure/single-walled carbon nanotube (GMS/SW...

A series of x(Co, Mn)/TiO2 catalysts (x=2–12wt.%) containing 25%Co and 75%Mn were prepared by the co-impregnation method. All prepared catalysts have been tested in Fischer-Tropsch synthesis for production of C2-C4 olefins. It was found that the catalyst containing 8wt.%(Co,Mn)/TiO2 is an optimal catalyst for production of C...

tio2 photo catalyst was prepared in presence of nano sio2 and hydroxy propyl cellulose (hpc) by sol gel method with titanium tetra isopropoxide (ttip) as titanium precursor. additional effect of hpc in preparation of nano catalyst, and photo catalyst properties measured and characterized by ft-ir, ft-raman and sem. the catalyst size and structural properties of the film were determined by .-ray...