Multilevel voltage source inverters have several advantages compare to traditional voltage source inverter. These inverters reduce cost, get better voltage waveform and decrease Total Harmonic Distortion (THD) by increasing the levels of output voltage. In this paper Genetic Algorithm (GA) and Particle Swarm Optimization (PSO) methods are used to find the switching angles for achieving to the m...

This paper presents detailed modeling and simulation of a compensator for Load balancing and harmonics Compensation based on a five-level cascaded H-bridge multilevel voltage source inverter. This type of compensator, which is installed in parallel with the load, is usually referred to as the shunt active power filters (APF). Nowadays use of high voltage non-linear loads are widely used in indu...

A New Static Var Generator (SVG), using cascaded full-bridge inverters (FBI) with binary output levels and the parallel connections of two cascaded inverters by means of current sharing reactor in each phases is introduced. The new M-level inverter, where M is 2n+2 - 3, consists of only 2n single-phase full bridges for each phases. The proposed technique not only increases the current capacity ...

This article presents a novel cascaded multilevel inverter as an alternative to the H-bridge (CHB). By adopting two H-bridges integrated with inductors and power switches, proposed topology is able generate five-level voltage merely single dc source. Voltage-boosting capability guaranteed despite its single-stage operation. A corresponding modulation technique also established charge boost cons...

This paper presents an investigation of five-Level Cascaded H – bridge (CHB) Inverter as Distribution Static Compensator (DSTATCOM) in Power System (PS) for compensation of reactive power and harmonics. The advantages of CHB inverter are low harmonic distortion, reduced number of switches and suppression of switching losses. The DSTATCOM helps to improve the power factor and eliminate the Total...

In this paper three-phase isolated source and non-isolated source cascaded two level inverter (CTLI) topology is used for grid connected photovoltaic (PV) system. The CTLI is one of the widespread topology in multilevel inverter. In this work, both topology isolated source and non-isolated source CTLI system are operated to supply active power with available solar irradiance and to supply react...

In PWM inverter-fed drives, a variation of Common mode voltage (CMV) causes unbalanced voltage operation in induction motor. Multilevel inverters reduce this problem, but the complexity of the power circuit increases with an increase in the number of inverter voltage levels. In this paper, a five-level inverter is compared with two, three and four levels and this five level structure is propose...

This paper deals with Single Phase Five level Inverter using Multi Carrier Based Pulse width modulation Technique. The voltage quality of conventional two level inverter is poor due the presence of harmonics and hence produces power loss which reduces the efficiency of the system. The multilevel inverter is used to improve the voltage quality by reducing the harmonics, as the number of voltage ...