Over the last ten years, robustness of schemes has raised an increasing interest among the CFD community. The objective of this article is to solve the quasi-one-dimensional compressible flow inside a “Shubin nozzle” and to investigate Bean-Warming and flux vector splitting methods for numerical solution of compressible flows. Two different conditions have been considered: first, there is a sup...

In this research mass transfer coefficient under jetting regime in different directions (from dispersed to continuous and continuous to dispersed phase) has been studied using an experimental setup. n-Butanol-succinic acid-water with low interfacial tension has been selected as experimental chemical system. The effects of various parameters such as jet velocity, nozzle diameter and the heig...

In view of the uneven artificial sowing, low sowing, as well as the fact that the existing seeders cannot meet the sowing requirements of Pteris vittata, this paper designed an automatic plug seeder by using the method of spraying and sowing after mixing spores and water. In order to obtain the optimum working parameters of the seeder, response surface method (RSM) was employed to desi...

An experimental and numerical analysis of a low-angle annular expander nozzle is presented to observe the variance in shock structure within the flow field. A RANS-based axisymmetric numerical model was used to evaluate flow characteristics and the model validated using experimental pressure readings and schlieren images. Results were compared with an equivalent convergingdiverging nozzle to de...

the main task of drilling the formation by the bit is done via scraping, crushing and grinding. discharging the fluid from the bit nozzles is done with high pressure which assists to break the rocks. different parameters affect the bit selection and design for each drilling formation, but the most important one is drillability that depends on hardness of the formation. in this paper, the design...

To improve the calculation of the flow properties of an aerospike nozzle, different turbulence models were investigated in this study. The primary shape of the nozzle plug is determined through utilizing an approximate method. The flow field is, then, simulated using the Navier-Stokes equations for compressible flows. The commercial computational fluid dynamics code Fluent is used to simulate t...

The increased concern about environmental effect of off-target deposits of pesticides use has resulted in the development of numerous spray drift models. Statistical models based on experimental field studies are used to estimate off-target deposits for different sprayers in various environmental conditions. Random-walk and computational fluid dynamics (CFD) models have been used to predict the...

It has been suggested that rising bubbles in dense fluids resemble an inverted dripping faucet and that they undergo analogous period-doubling bifurcations to chaos. We present experimental results demonstrating that this analogy is weak because the dominant source of instability in the bubble train is inherently different mutual interactions between spatially separated bubbles as opposed to no...

Planar Laser-Induced Fluorescence PLIF is employed to measure rotational temperatures at the nozzle exit of a free-piston shock tunnel. The ow is at approximately Mach 7 and chemical eeects have been reduced by using a nitrogen test gas and low total enthalpy 5 MJJkg. Vibrational freezing in the nozzle expansion has an appreciable effect on the nozzle-exit rotational temperature, and therefore ...