The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...

Iron chromium oxide microspheres were generated by pulsed laser irradiation on the surface of two commercial samples of stainless steel at room temperature. An Ytterbium pulsed fiber laser was used for this purpose. Raman spectroscopy was used for the characterization of the microspheres, whose size was found to be about 0.2-1.7 μm, as revealed by SEM analysis. The laser irradiation on the surf...

Soft X-ray absorption spectroscopy (XAS) has been used to study the influence of Si ion implantation on the passive layer of AISI 304 stainless steel, as well as on its high-temperature oxidation behaviour. Ion implantation is a usual technique to improve the corrosion and oxidation resistance of steels. To study the effects of ion implantation on the room temperature corrosion behavior of AISI...

The effect of several Almen intensities of shot peening on the corrosion behavior, surface roughness, micro hardness profiles, and residual stresses of stainless steel AISI 316 L were investigated. Hydroxyapatite coating (HA) were applied to shot peened materials to improve their corrosion resistance. The corrosion behaviour were studied using potentiodynamic polarization. The electrochemical t...

Introduction The mechanical properties of austenitic stainless steels, including the low cyclic fatigue behavior have been a subject of numerous studies [1-8]. Nitrogen addition, in general, increases the fatigue strength by decreasing the stacking fault energy of austenitic stainless steels [6]. The stacking fault energy has a strong influence on the cross slip difficulty, thus it affects the ...

Frettingwear between a hemisphere and a flat plate is investigated experimentally and the effect of laser polishing is studied. The energy dissipated between the hemisphere and the flat plate is determined as eceived in revised form 23 April 2010 ccepted 28 April 2010 vailable online 13 May 2010 eywords: retting a function of operating conditions such as frequency and normal load and material p...

Plastic pre-strains were applied to the metastable 304L austenitic stainless steel at both room temperature (20 °C) and higher temperatures (i.e., 50, 80 and 100 °C), and then the hydrogen embrittlement (HE) susceptibility of the steel was evaluated by cathodically hydrogen-charging and tensile testing. The 20 °C pre-strain greatly strengthened the steel, but simultaneously significantly increa...

This paper examines a few methods used in grounding analysis and illustrates the advantages, limitations, and the applicability of these methods. Computation results using these methods are presented and compared. The various cases modeled in this paper include grounding networks of different sizes, grounding networks with buried metallic structures such as steel pipes, and high frequency cases...

In order to investigate lattice defects of 18-8 stainless steel after solution, precipitation and resolution treatments, thin films prepared from bulk specimens after the heat treatments were examined by means of transmission electron microscopy. In addition, measurements of the internal friction, specific gravity and electrical resistivity as well as Huey corrosion tests were conducted. The ex...