The effect of heat source/sink on steady two-dimensional laminar MHD mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3...

Single and multi-phase numerical simulations are carried out to investigate the heat transfer and entropy generation behaviour of transitional flow of TiO2 H2O nanofluid in a circular pipe. Results reveal that the small diameter of nanoparticles has the highest heat transfer rate for χ = 6% and the TiO2-water nanofluid shows higher heat transfer rate using multi-phase model compared to that of ...

Sometimes the need for non-circular ducts arises in many heat transfer applications because of lower pressure drop of non-circular cross section such as square duct compared to circular tube, particularly in compact heat. But square cross section has poor heat transfer performance and it is expected that using a nanofluid as a new heat transfer media may improve the heat transfer performance of...

Nanofluid is a new class of heat transfer fluids engineered by dispersing metallic or non-metallic nanoparticles with a typical size of less than 100 nm in the conventional heat transfer fluids.This article aims to investigate the overall and convection heat transfer coefficient and Nusselt number of Al2O3-water nanofluid flowing in a horizontal double pipe heat exchanger under turbulent flow (...

This study aims at the calculation of pressure drop from simulation internal nanofluid flow in a new and long stainless pipe (1.4 m 0.01 diameter). Calculations were made numeric simulations which based on theoretical models experimental proprieties three nanofluids: graphene nanodiscs with water, titanium oxide nanospheres water iron water. Different concentrations considered each kind nanoflu...

In this paper, we investigate the effect of adding a stabilizer on the dynamic thermal properties of ZnO nanofluid (containing 5 to 10 nm diameter of ZnO nanocrystals) measured using a 3ω method. Addition of the stabilizer leads to the stabilization of the nanofluid and also substantial reduction of the enhancement of thermal transport compared to that seen in the bare ZnO nanofluid. This also ...

Forced convection boundary layer magnetohydrodynamic flow of a nanofluid over a permeable stretching plate is studied in this paper. The effects of suction-injection and viscous dissipation are taken into account. The nanofluid model includes Brownian motion and thermophoresis effects. The governing momentum, energy, and nanofluid solid volume fraction equations are solved numerically using an ...

In this paper the thermal convective instabilities of a binary nanofluid is theoretically investigated. In order to analyze a binary nanofluid, an addition factor is proposed under linear stability theory which is applied to the stability analysis of normal fluid. The factor describes the effect of nanoparticles on the convective instability of a basefluid. The Soret effect which represents the...

The thermosolutal instability problem in a horizontal layer of an elasticoviscous nanofluid in porous medium is considered. Walters’ (model B') fluid model is employed to describe the rheological behavior of the nanofluid and for the porous medium, the Darcy model is employed. From the linear stability analysis based upon normal modes analysis method, the dispersion relation accounting for the ...