نتایج جستجو برای: wall heat flux

تعداد نتایج: 440913  

2004
Dinesh K. Prabhu

H : specific total enthalpy α : angle of attack h : specific static enthalpy β : sideslip (yaw) angle J r : mass diffusion flux vector γs : recombination coefficient L : characteristic length ∆s : wall-normal grid spacing M : Mach number or molar mass ε : emissivity n : unit normal κ : gas mixture thermal conductivity p : Pressure μ : gas mixture viscosity Q : heat load σ : Stefan-Boltzmann con...

2009
M. Sunder D. Banerjee

0142-727X/$ see front matter 2008 Elsevier Inc. A doi:10.1016/j.ijheatfluidflow.2008.08.003 * Corresponding author. Tel.: +1 979 845 4500; fax E-mail address: [email protected] (D. Banerjee Surface temperature fluctuations that occur locally underneath departing bubbles in pool boiling are shown to result in local heat transfer coefficients ranging from 1 to 10 kW/cm. These estimates were repo...

H. Khorasanizadeh, J. Amani M. Hemmat M. Nikfar

This paper presents results of a numerical study of mixed convection and entropy generation of Cu–water nanofluid in a square ventilating cavity at different inclination angles. Except a piece of bottom wall with a uniform heat flux, all of the cavity walls are insulated. The inlet port is placed at the bottom of the left wall and the outlet port is positioned at the top of the right wall....

2004
Kamil Wichterle

Flow and thermal convection in heat exchangers can be affected by variations in viscosity. In circular pipes the significance of this effect was expressed by Sieder and Tate’s empirical formula. Similar correction can be derived for other heat transfer problems. Exact solutions for heat transfer during the non-isoviscous laminar flow of Newtonian and non-Newtonian liquids in circular and flat d...

2015
Mohammad Fakoor Pakdaman Majid Bahrami

Developing next generation transient heat exchangers is a transformative technology for efficient ther-mal management of advanced power electronics and electric machines (APEEM) inside hybrid electric,electric, and fuel cell vehicles as well as renewable energies (wind, solar, tidal). Optimal design criteriafor such dynamic heat exchangers should be achieved through addressing inter...

2002
SHUICHI TORII

Numerical analysis is performed to investigate transport phenomena in channel flows under uniform heating from both side-walls. Emphasis is placed on an effect of heat flux ratio from both sides on the velocity and thermal fields. The twoequation heat-transfer model is employed to determine thermal eddy diffusivity. It is found that (i) under strong heating from both walls, laminarization, i.e....

Journal: :international journal of advanced design and manufacturing technology 0
meysam atashafrooz department of mechanical engineering, sirjan university of technology, sirjan, iran seyyed abdolreza gandjalikhan nassab department of mechanical engineering, shahid bahonar university of kerman, kerman, iran khosro lari department of mechanical engineering, graduate university of advanced technology, kerman, iran

in this research, the coupling between non-gray radiation and separation convection flow in a duct is investigated numerically. distributions of absorption coefficients across the spectrum  are obtained from the hitran2008 database. the full-spectrum k-distribution method is used to deal with the non-gray part of the problem, while the gray radiation calculations are performed using the planck ...

ثقفیان, محسن, رجبی, رمضان,

In this paper, viscous dissipation and roughness effects on heat transfer and fluid flow are investigated in microchannels using perturbation method in slip flow regime. The flow is considered to be laminar, developing thermally and hydrodynamically, two-dimensional, incompressible and steady-state. The working fluid is air, flowing between two parallel plates. The equations obtained from devel...

2018
Zeyuan Cheng Zhi Tao Jianqin Zhu Hongwei Wu

This article presented a numerical investigation of supercritical heat transfer of hydrocarbon fuel in a series of horizontal tubes with different diameters. It has been carried out by solving Reynolds averaging equations of mass, momentum and energy with the LS low-Reynolds number turbulence model using the pressure-based segregated solver based on the finite volume method. For the purpose of ...

Journal: :Mechanical Engineering Reviews 2014

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید