The breakage of capsules upon crack propagation is crucial for achieving crack healing in encapsulation-based self-healing materials. A mesomechanical model was developed in this study to simulate the process of crack propagation in a matrix and the potential of debonding. The model used the extended finite element method (XFEM) combined with a cohesive zone model (CZM) in a two-dimensional (2D...

In this article, high-speed photographic investigations of the dynamic crack initiation and propagation in several inorganic glasses by the impact of small spherical and conical projectiles are described. These were carried out at speeds of up to approximately 2×10(6) frames s(-1). The glasses were fused silica, 'Pyrex' (a borosilicate glass), soda lime and B(2)O(3). The projectiles were 0.8-2 ...

In this study, fatigue test and crack propagation analysis of welded joints in ships and offshore structures were performed. The test models have two types of welded joints, T-joint and double plate. Test data is presented in S-N curves obtained by the Hot Spot Stress (HSS) approach. The S-N data for each length of crack were appraised to define the fatigue life of crack initiation and propagat...

A large number of bridges in the federal inventory are reaching the end of their design life due to aging and environmental degradation. The situation is aggravated by increased traffic needs that require existing structures to carry heavier loads at increasingly higher speeds. Project Summary: The issue of moisture diffusion in composite materials is important because of its associated problem...

Damage tolerance can be an elusive characteristic of structural materials requiring both high strength and ductility, properties that are often mutually exclusive. High-entropy alloys are of interest in this regard. Specifically, the single-phase CrMnFeCoNi alloy displays tensile strength levels of ∼ 1 GPa, excellent ductility (∼ 60-70%) and exceptional fracture toughness (KJIc>200 MPa√m). Here...

Fatigue tests have been conducted on an advanced disc Ni-based superalloy (Low Solvus, High Refractory (LSHR) alloy) at 650 C in air under three-point bend loading to investigate the role of orientation-dependent grain boundary oxidation in crack initiation and early propagation. It is found that crack initiation occurs mainly from bulged grain boundary oxides, and cracks then predominantly pro...

In this research, a slotted patch antenna sensor is designed for wireless strain and crack sensing. An offthe-shelf RFID (radiofrequency identification) chip is adopted in the antenna sensor design for signal modulation. The operation power of the RFID chip is captured from wireless reader interrogation signal, so the sensor operation is completely battery-free (passive) and wireless. For strai...

Repairing of the cracks by fiber metal laminates (FMLs) was first done by some aeronautical laboratories in early 1970s. In this study, experimental investigations were done on the effect of repairing the center-cracked aluminum plates using the FML patches. The repairing processes were conducted to characterize the response of the repaired structures to tensile tests. The composite patches wer...

In a remarkable series of experiments, Elssner et al. (1994) and Korn et al. (2002) observed cleavage cracking along a bimaterial interface between Nb and sapphire. The stress required for cleavage cracking is around the theoretical strength of the material. Classical plasticity models fall short to reach such a high stress level. We use the conventional theory of mechanism-based strain gradien...

Crack initiation and growth behaviour of an austempered ductile iron (ADI) austenitised at 800C and austempered at 260C has been assessed under three point bend fatigue conditions. Initiation sites have been identified as carbides remaining from the as cast ductile iron due to insufficient austenisation. The number of carbides cracking on loading to stresses greater than 275 MPa is critical in ...