Abstract In this paper, an experimental simulation method was used for evaluating the tribofilm formation in rolling/sliding contact at different points line of action. A ball-on-disc test employed by which pressure and slide to roll ratio gear could be simulated. order reach a general conclusion, four oils two surface roughness were involved experiments. The evolution captured using spacer lay...

The following paper will describe a methodology for automatically detecting and diagnosing rolling element bearing wear. The techniques involved have been proven in over 15 years of use in a huge variety of environments, machine types and applications. The techniques involved in diagnosing bearing wear will be described in detail and supported by a set of example graphs and an annotated diagnos...

nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. in this paper, ultrasonic assisted turning (uat) isperformed to create the micro textures on the flat faces. micro surface texturing ismade on the al7075-t6 by the uat in the face turning process. then, the influences of cutting speed feed, vibration direction and vibration ampl...

In this article, we present a critical review of the swimming literature on body roll, for the purposes of summarizing and highlighting existing knowledge, identifying the gaps and limitations, and stimulating further research. The main research findings can be summarized as follows: swimmers roll their shoulders significantly more than their hips; swimmers increase hip roll but maintain should...

An Al/Stainless Steel/Al lamellar composite was produced by roll bonding of the starting sheets at 400 °C. Afterward, the roll bonded sheet was cut in half and the accumulative roll bonding (ARB) process at room temperature was applied seven times. As a result, the central steel layer fractured and distributed in the Al matrix among different layers introduced by the repetition of roll bonding ...

In order to automate the scooping task, it is desirable that the resistive force acting on the bucket be obtained before the scooping is performed. The objective of this study is to derive theoretically the resistive forces acting on the bucket during scooping of piled rock fragments. First, the changes in the shape of the rock pile due to the penetration of it by the bucket are modeled. Based ...

Analytical models for channel potential, threshold voltage, and subthreshold swing of the short-channel fin-shaped field-effect transistor (FinFET) are obtained. The analytical model results are verified against simulations and good agreements are observed. Analytical expressions for subthreshold swing, drain induced barrier lowering effect, and threshold voltage roll-off characteristics are pr...

In this paper, an analytical method based on Modified Slab Method of analysis is presented to study the asymmetrical rolling process due to difference in work rolls radii, rolls speeds and interface frictions. The shear force imposed on material along the contact region is considered to be a function of the frictional factor and the roll gap geometry. Elastic-plastic with linear work hardening ...