One of the ways to waste energy in buildings is wasting it from the walls. For this reason, insulating materials are used to prevent the loss of energy in buildings. Typically, common insulations are high thickness and thin coatings are used less. The purpose of this research is to introduce nanocomposite thin polymer coatings and its effect on thermal conductivity. For achieving this, chemical...

plasters are produced from a light refractory material, mainly mgo (m.p. 2800ºc), a binder, and a void forming substance for insulating purposes. different oxides from the slag penetrate into these voids and provide low melting-point phases suchasrhodonite (mnsio3) (1290ºc), tephorite (mn2sio4) (1345ºc), merwinite (ca3mgsi2o8) (1575ºc), monticellite (camgsio4) (1490ºc), and enstatite (mgsio3) (...

Dissolved gas analysis (DGA) is attracting greater and greater interest from researchers as a fault diagnostic tool for power transformers filled with vegetable insulating oils. This paper presents experimental results of dissolved gases in insulating oils under typical electrical and thermal faults in transformers. The tests covered three types of insulating oils, including two types of vegeta...

Abstract The employment of atomic layer deposition and spin coating techniques for preparing inorganic–organic hybrid multilayer structures alternating ZnO-CNC layers was explored in this study. Helium ion microscopy X-ray reflectivity showed the superlattice formation nanolaminate force established efficient control CNCs surface coverage on Al-doped ΖnO by manipulating concentration solution. ...

the infrastructure of the electricity grid and super grid system in the hitherto industrialized world was to a large extent built up in the decades following world war ii with a peak in investments around 1960-1980. this means that the flotilla of power transformers is now starting to reach projected lifetime of around 40 years. during the last couple of decades there has also been an ongoing d...

Cross-linked polyethylene (XLPE) is an appropriate insulating material for high-voltage cables which has been widely used as electrical cable coating. In this study, Crushed XLPE wastes with different volume percentages (25, 50, and 75%) were used in hot mix asphalt (HMA) as a substitute for fine aggregates remained on sieve no. 8 whose size varies from 1.18 to 2.36 mm. The dynamic stiffness (i...

The infrastructure of the electricity grid and super grid system in the hitherto industrialized world was to a large extent built up in the decades following World War II with a peak in investments around 1960-1980. This means that the flotilla of power transformers is now starting to reach projected lifetime of around 40 years. During the last couple of decades there has also been an ongoin...

The phenolic antioxidants 2,6-ditertiary-butyl paracresol (DBPC) (also known as butylated hydroxytoluene (BHT)) and 2,6-ditertiary-butyl phenol (DBP) are the two most common oxidation inhibitors added to the electrical insulating (transformer) oil and mineral oil based lubricants. The typical recommended value of DBPC and DBP in fresh electrical insulating oil is approximately 0.3% by weight. T...

Charge separation near a liquid/solid interface is explored by the electrohydrodynamic pumping of Freon TF, transformer oil, and silicone oil using high voltage traveling waves. Liquid head displacement measurements show strong dependencies on peak voltage amplitude (1.0-2.5 kV), frequency (0.1-20 Hz), liquid viscosity (0.5-20 cS), and liquid conductivity to 10-9 0-lm-l ). Reverse pumping, oppo...

Recent advances in inkjet-printed organic field-effect transistors (OFETs) based on organic semiconductor/insulating polymer blends are reviewed in this article. Organic semiconductor/insulating polymer blends are attractive ink candidates for enhancing the jetting properties, inducing uniform film morphologies, and/or controlling crystallization behaviors of organic semiconductors. Representat...