Soil fumigants are used to control a wide variety of soil-borne pests in high-cash-value crops. Application of soil fumigants through drip irrigation systems is receiving increasing attention as a method to improve the uniformity of fumigant application. Little information is available on the emissions and soil distribution of fumigants following subsurface drip application, or the effect of pl...

Selective laser sintering (SLS) has been investigated for the production of bioactive implants and tissue scaffolds using composites of high-density polyethylene (HDPE) reinforced with hydroxyapatite (HA) with the aim of achieving the rapid manufacturing of customized implants. Single-layer and multilayer block specimens made of HA-HDPE composites with 30 and 40 vol % HA were sintered successfu...

Banana fiber (BaF)-filled composites based on high density polyethylene (HDPE)/Nylon-6 blends were prepared via a two-step extrusion method. Maleic anhydride grafted styrene/ethylene-butylene/styrene triblock polymer (SEBS-g-MA) and maleic anhydride grafted polyethylene (PE-g-MA) were used to enhance impact performance and interfacial bonding between BaF and the resins. Mechanical, crystallizat...

A detection system using room-temperature, microstructured solid-state thermal neutron detectors with very low leakage current has been developed at Rensselaer Polytechnic Institute (RPI) with the ability to provide positional and spectral information about an unknown neutron source. The Directional and Spectral Neutron Detection System (DSNDS) utilizes a set of small-but-scalable, zero-bias so...

This study reports an application of instrumental color measurement for quantifying and comparing the optical properties of high density polyethylene HDPE and low density polyethylene LDPE blend films and the effect of blending ratio and miscibility on these properties. The technique of spectrophotometry in transmission and reflectance modes can be used as a versatile tool to evaluate the color...

injection molding is one of the most common processes which are used for manufacturing different plastic parts. this method includes 3 continuous steps: filling of the mold, cooling and driving the part out. a wide range of plastic and non-plastic materials can be used as raw material in this process. one of the most important advantages of this way of production is that it is very economic. in...