Grinding and polishing are widely used surface finish operations for a variety of precision and delicate component of ceramics, such as silicon wafers and gauges. However, the formation and evaluation of the subsurface damage induced have not been investigated, although subsurface damage is extremely important to the quality of the products. Grinding and polishing are usually carried out by a s...

The aim of this study was to determine a suitable amount of grinding of a flexural test specimen for clinical evaluation of dental ceramics. Three dental ceramics (Crys-Cera, OCC and IPS Empress Cosmo) were selected. Five types of bar-shaped patterns were prepared for a three-point bending test, and four types of disk-shaped patterns for a biaxial flexural test. Ceramic specimens were fabricate...

-A vermiculite (Libby, Montana) sample obtained from the Zonolite company contained mostly coarse-grained separates with only 8.7 per cent clay. The 2-50 #m fraction was used for particle-size reduction studies by wet and dry grinding, and size-fractionated into < 2, 2-5, 5-20 and 20--50 #m sizes. About 18 per cent of the sample was attrited to clay after 64 hr of wet grinding, but as much as 5...

The purpose of this paper is to understand the combined effect of thermal and mechanical plastic deformation on residual stresses in ground components. The interactions between a grinding wheel and a workpiece, including both thermal and mechanical interaction, are simulated by triangular surface loads moving with the table speed of grinding. Cooling is modelled by a uniform convection over the...

Industrial robots are introduced to belt grinding processes of free-formed surface with elastic wheel nowadays in order to obtain high quality product and high efficiency. However, it is a laborious task to plan grinding paths and write programs for the robot. To release people from it partially, it is necessary to simulate the belt grinding processes which are useful for path generating and dy...

In the current work we present approach to study the mechanism of the cutting of abrasive grains in the grinding wheel using finite element analysis (FEA). The simulation process is done by separating two abrasive grains from the grinding wheels and the microprocess of material removal in the case of surface grinding is simulated. Modelling was done on the workpiece steel S-7 and material grain...

THE ATTRITIOUS AND FRACTURE WEAR OF GRINDING WHEELS by Stephen Malkin Submitted to the Department of Mechanical Engineering February 1968, in partial fulfillment of the requirements for the degree of Doctor of Science A detailed investigation is made of the nature and extent-of grinding wheel wear in finish grinding. The wear is broadly classified as either attritious or fracture wear. Attritio...

Copper smelting slags are hard materials. Therefore,to recover their copper by flotation method, grinding should be carried out to obtain optimal particle size. Copper smelting slags in the Bardeskan district, with work index of 16.24 kwh/st, were grinded for 65 minutes to reach an acceptable degree of freedom for the flotation tests, with particle size of 80%, smaller than 70 μm. With this gri...

In this study; utilizing the elastic matrix ball has higher processing efficiency and better superficial quality than traditionalgrinding. The diversity of elastic abrasive tool characteristics contact with bend surface results in irregular wear abrasion，and abrasive tool machining status gets complicated. There is no theoretical interpretation of parameters affecting the grinding accuracy. Bec...

In this study; utilizing the elastic matrix ball has higher processing efficiency and better superficial quality than traditionalgrinding. The diversity of elastic abrasive tool characteristics contact with bend surface results in irregular wear abrasion，and abrasive tool machining status gets complicated. There is no theoretical interpretation of parameters affecting the grinding accuracy. Bec...