This paper presents the study of fluid flow and heat transfer in a plain rectangular duct of a solar air heater by using Computational Fluid Dynamics (CFD). The effect of Reynolds number on heat transfer coefficient and friction factor was investigated. A commercial finite volume package ANSYS FLUENT 12.1 is used to analyze and visualize the nature of the flow across the duct of a solar air hea...

Developing the thermodynamics of nanoscale friction is needed in a wide range tribological applications, where key objective to optimally control energy dissipation. Here we show that modern stochastic allows us interpret measurements obtained by force microscopy, which standard tool for investigating frictional properties materials, terms basic concepts such as fluctuating work and entropy. We...

in this paper the effect of block shape vortex generators (vgs) on an air-water fin-tube heat exchanger has been studied experimentally using exergy analysis method. also the effect of these vgs on increasing heat transfer rate has been simulated numerically and the results show a good agreement with the experiments. in this research we used a wind tunnel to produce wind flow over heat exchange...

OBJECTIVE To quantify the concentration of superficial zone protein (SZP) in the articular cartilage and synovial fluid of patients with advanced osteoarthritis (OA) and to further correlate the SZP content with the friction coefficient, OA severity, and levels of proinflammatory cytokines. METHODS Samples of articular cartilage and synovial fluid were obtained from patients undergoing electi...

in this paper, finite element model of woven fabric target has been investigated which is impacted by a cylindrical projectile. fabrics are impregnated with shear thickening fluid (stf). the effects of the (stf) have been considered as frictional effect. the stf has been made (nano silica and polyethylene glycol (peg)) and then diluted by ethanol proportion of 3:1. yarn pulling out test from in...

AbstractHydroforming process is a deep stretching process only with the difference that a fluid is used instead of the mandrel. This paper investigates the hydroforming process of non-cylindrical and non-spherical geometries using finite element analysis software to calculate the influences of effective process parameters such as the coefficient of friction between the surfaces and the pressure...

in the computational fluid dynamics (cfd) modeling of gas-solids two phase flow, the effect of boundary conditions play an important role in predicting the hydrodynamic characteristics of fluidized beds. in this work, the hydrodynamics of conical fluidized bed containing dried tio2 nano-agglomerates were studied both experimentally and computationally. the pressure drop was obtained by pressure...

We propose a one-fluid analytical model for a turbulently flowing dilute suspension, based on a modified Navier-Stokes equation with a k-dependent effective density of suspension rho(eff)(k) and an additional damping term proportional, variant gamma(p)(k), representing the fluid-particle friction (described by Stokes law). The statistical description of turbulence within the model is simplified...

[1] Knowledge of frictional resistance along faults is important for understanding the mechanics of earthquakes and faulting. The clearest in situ measure of fault friction potentially comes from temperature measurements in boreholes crossing fault zones within a few years of rupture. However, large temperature signals from frictional heating on faults have not been observed. Unambiguously inte...

The characteristics of fully-developed, laminar, pressure-driven, incompressible flow in rough circular microchannels are studied. A novel analytical model is developed that predicts the increase in pressure drop due to wall roughness in microtubes. The wall roughness is assumed to posses a Gaussian isotropic distribution. The present model is compared with experimental data, collected by other...