The electrical discharge machining (EDM) process is mostly used in conditions that complex and intricate shapes need to be machined on very hard metals. However, the leaves behind some undesirable properties such as high surface roughness, rough topography, residual tensile stresses, micro-cracks, heat-affected zone (HAZ), recast layer. This paper investigates effects of different output parame...

Electrical discharge machining (EDM) provides many advantages for the shaping of metallic materials. It also better surface quality Ti alloys used in defense industry. In this study, experiments were carried out with different EDM parameters using Titanium (Gr2) alloy. A number novel industrial processes have been developed as a result advances technology. For product to be developed, these app...

Electrical Discharge Machine (EDM) parameters have a significant influence on machining characteristic like material removal rate (MMR) and tool wear rate (TWR). Inconel 718, which is widely used in the Medical, Marine, Architectural and food processing industries, is used as a work material. The tool electrode materials used are brass. Experiments are conducted using face centered central comp...

We discuss in detail the search for a permanent electric dipole moment (EDM) of the 199Hg atom reported by Griffith et al. [Phys. Rev. Lett. 102, 101601 (2009)]. The upper bound, d(199Hg) < 3.1 × 10−29 e cm (95% C.L.), is a factor of 7 improvement over the best previous EDM limit for 199Hg, provides the most sensitive probe to date for EDMs in diamagnetic atoms, and sets new limits on time-reve...

Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...

in this work, the influence of different edm parameters (pulse current, pulse voltage, pulse on-time , pulse off-time) in finishing stage on  the surface roughness (r a )  as a result of application copper electrode to a workpiece( cold work steel  din1.2379)  has been investigated. design of the experiment was chosen as full factorial. statistical analysis has been done and artificial neural n...

INSTRUCTIONS The diameter of silicon wafer becomes larger in order to increase the number of chips per one wafer. For such a larger diameter silicon ingot is mainly sliced by using multi-wire method, in which a long thin wire is used with slurry. In this method, several hundreds of wafers could be sliced at the same time. However there are still problems remained, such as large cracks, slurry t...

This paper reports on ongoing work about heterogeneous and cross-domain data conversion to a common data model in EuropeanaConnect. The “Europeana Data Model” (EDM) provides the means to accommodate data from different domains while mostly retaining the original metadata notion. We give an introduction to the EDM and demonstrate how important metadata principles of two different metadata standa...

If electrons had an electric dipole moment (EDM) they would induce EDMs of atoms. The ratio of the atomic EDM to the electron EDM for a particular atom is called the enhancement factor, R. We calculate the enhancement factor for the francium and gold atoms, with the results 910± ∼ 5% for Fr and 260± ∼ 15% for Au. The large values of these enhancement factors make these atoms attractive for elec...

If electrons had an electric dipole moment (EDM) they would induce EDMs of atoms. The ratio of the atomic EDM to the electron EDM for a particular atom is called the enhancement factor, R. We calculate the enhancement factor for the francium and gold atoms, with the results 910± ∼ 5% for Fr and 260± ∼ 15% for Au. The large values of these enhancement factors make these atoms attractive for elec...