An Alternate Arm Modular Multilevel Converter (AAMMC) is the recently introduced power electronics converter topology suitable for High Voltage DC Transmission (HVDC) system applications. This paper focuses on the operating principle of an Alternate Arm Modular Multilevel Converter. At the beginning the advantages of multilevel converter, basic schematic of converter topology, and its operation...

This paper describes a new design for direct sliding mode method with a high switching frequency using the PD-PI type sliding surface applied to a negative output Luo converter worked in continuous current mode for applications required constant power source such as aerospace applications, medical equipment and etc. Because of the output power and line changes, the converter model is also nonli...

This paper introduces a bi-directional DC-DC converter with adaptive fuzzy logic controller (AFLC). Bi-directional power flow is obtained by the same power components and provides a simple, efficient, and galvanically isolated converter. In the presence of DC mains, the converter operates as buck converter, powers the down stream converter, and also charges the battery. When the DC mains fails,...

The fly back converter has been widely used for multi outputs due to the simple structure and low cost in low-power applications. This paper presents a new multi output converter. It consists of a half-bridge inverter with boost converter in primary side and a fly back rectifier that is integrated with an auxiliary buck converter in secondary side. The boost converter is used to generate high v...

In this paper, a new structure for buck-boost Z-source converter based on Z-H topology is proposed. The proposed converter consists of two LC networks similar to the conventional Z-source and Z-H converters. One of the characteristics of the proposed structure is that, without any changing in its’ power circuit, it can be used in different conversions such as dc/dc, dc/ac and ac/ac. This unique...

− In this paper, small signal characteristic of a LLC resonant converter is analyzed. LLC resonant converter was been reported in many papers recently because of its simple structure, high efficiency and high switching frequency capability. In order to make practical use of this topology, understanding its small signal characteristic is essential to design the control loop. For PWM converter, s...

With the development of power electronics devices, resonant converter is proved to be more efficient than conventional converter as it employs soft switching technique. Among the three basic configuration of resonant converter, Series Resonant Converter (SRC), Parallel Resonant Converter (PRC) and Series Parallel Resonant Converter (SPRC), the LLC configuration under SPRC is proved to be most e...

In the current study, reduction of nitrogen oxide from exhaust gas in the presence of NH3 as reductant on selective catalytic reductant (SCR) impregnated catalytic converter was simulated using Comsol© software. Mass transfer (one-dimensional) and heat transfer (three-dimensional) governing equations were taken into account to model the unsteady state behavior of the catalytic converter. Modeli...

In this paper fractional order averaged model for DC/DC Buck converter in continues condition mode (CCM) operation is established. DC/DC Buck converter is one of the main components in the wind turbine system which is used in this research. Due to some practical restriction there weren’t exist input voltage and duty cycle of converter therefor whole of the wind system was simulated in Matlab/Si...