A square splittered and unsplittered rod is placed in a turbulent boundary layer developed over a flat plate. The effect of the resulting disturbances on the local heat transfer coefficient is then studied. In both cases the square rod modifies the flow structure inside the boundary layer. As a result, a stagnation point, a jet and wake area are generated around the square rod, each making a co...

A nanofluid is mixture of nano sized particles and a base fluid. This paper investigates by using laboratory based double pipe heat exchanger model, the performance of nanofluid containing about 48.46nm  particle size nanoparticles (ZnO) without or with addition of nonionic surfactant Rokanol K7 (500ppm) into the base fluid double distilled water to prepared three different concentrations 1.0%,...

introduction: frying phenomena occur during the immersion of the product in oil at a temperature of 150–200 ºc, where a simultaneous heat and mass transfer take place. this is the most popular thermal processes of potato cooking. this fast drying is critical to improve the mechanical and structural properties of the final product. these conditions lead to high heat transfer rates, rapid cooking...

An experimental investigation was carried out to study mixed convection heat transfer from Al2O3-water nanofluid inside a vertical, W-shaped, copper-tube with uniform wall temperature. The tests covered different ranges of some involved parameters including Reynolds number, temperature and particles volume fraction. The results showed that the rate of heat transfer coefficient improved with Rey...

An experimental study for air-side thennal-hydraulic performance of brazed aluminum heat exchangers under dehumidifYing conditions has been performed. For 30 samples of louvered fin heat exchangers with different geometrical parameters, the heat transfer and pressure drop characteristics for wet surface were evaluated. The test was conducted for air-side Reynolds number in the range of 80-300 a...

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. in this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in pure ...

in this study, thermal performance of a cylindrical heat pipe is investigated numerically. three different types of water based nanofluids, namely (al2o3+water), (diamond+water) and (multi-wall carbon nano tube (mwcnt) +water) have been used. the influence of using the simple nanofluids and mwcnt nanofluid on the heat pipe characteristics such as liquid velocity, pressure profile, temperature p...

This thesis presents a series of three related studies with the aim of developing a surface that promotes robust dropwise condensation. Due to their remarkably low droplet adhesion, superhydrophobic surfaces were investigated for application to dropwise condensation. Although precise model superhydrophobic surfaces were necessary to gain insight into these phenomena, it was recognized that wide...