in order to simulate the rotating disk contactor all hydrodynamic parameters, dispersed phase hold-up, characteristic velocity, mean drop size, drop size distribution, axial mixing and mass transfer have been taken into account. mechanisms of mass transfer (stagnant, circulating, oscillating drops) were used in this study. column height found from effect of mean drop size and drop size distribu...

In this research, the effect of PEO procedure time on the distinct properties of coatings such as morphology, chemical composition, roughness and corrosion has been studied. A scanning electron microscopy equipped with an energy dispersive spectroscopy was used to study the microstructure of the coatings. In addition, x-ray diffraction (XRD) and roughness meter were used to evaluate the chemica...

This article presents a histologic evaluation of three hydroxyapatite (HA)-coated root-form implants retrieved from humans after being in function for 3.5 to 11 years. If the coronal portion, where bone loss was observed clinically and radiographically, is excluded, all implants appeared to be well osseointegrated, with intimate contact between the surrounding bone and the coating. There was no...

In this work we investigate theoretically the Landau-Levich problem of dip coating in the presence of a strong interaction potential normal to the substrate. This study is motivated by dip coating at very low capillary numbers when the deposited film thickness is less than 1 m and such interaction forces become important. The objective of this work is to demonstrate that in the presence of an e...

Immobilised titanium dioxide (TiO2) in membrane structures has recently become attractive. This is due to the elimination of the separation step after the process of photocatalytic degradation. The efficiency of the TiO2 surface area exposed to UV light as the main important parameter needs to be considered. The immobilisation of TiO2 nanoparticles in the polyvinylidene fluoride (PVDF) membrane...

Both blue- and redshifts of resonant modes are observed in the rolled-up Y2O3/ZrO2 tubular microcavity during a conformal oxide coating process. Our investigation based on spectral analyses suggests that there are two competitive processes during coating: desorption of both chemically and physically absorbed water molecules and increase of the tube wall thickness. The redshift is due to the inc...

It is shown that coating graphene-silicon (Gr/Si) Schottky junction based solar cells with graphene oxide (GO) improves the power conversion efficiency (PCE) of the cells, while demonstrating unprecedented device stability. The PCE has been shown to be increased to 10.6% (at incident radiation of 100 mW cm(-2)) for the Gr/Si solar cell with an optimal GO coating thickness compared to 3.6% for a...

A mechanism for crystal-crystal phase transformations (PTs) via surface-induced virtual premelting is justified thermodynamically and confirmed experimentally for the PTs in PbTiO3 nanofibers. When the thickness of the surface melt (which appears much below the melting temperature, especially for nanoobjects) exceeds the size of the critical product nucleus, nucleation and growth of the product...

Black carbon aerosols (BC) at a London urban site were characterised in both winterand summertime 2012 during the Clean Air for London (ClearfLo) project. Positive matrix factorisation (PMF) factors of organic aerosol mass spectra measured by a high-resolution aerosol mass spectrometer (HR-AMS) showed traffic-dominant sources in summer but in winter the influence of additional non-traffic sourc...