Layered multi-oxide concept was applied for fabrication of photoanodes for dye-sensitized solar cells based on ZnO and SnO2, capitalizing on the beneficial properties of each oxide. The effect of different combinations of ZnO@SnO2 layers was investigated, aimed at exploiting the high carrier mobility provided by the ZnO and the higher stability under UV irradiation pledged by SnO2. Bi-oxide pho...

In this article, using first-principles electronic structure calculations within the spin density functional theory, alternated magnetic and non-magnetic layers of rutile-CrO2 and rutile-SnO2 respectively, in a (CrO2)n(SnO2)n superlattice (SL) configuration, with n being the number of monolayers which are considered equal to 1, 2, ..., 10 are studied. A half-metallic behavior is observed for th...

In this paper we investigate the surface chemistry, including surface contaminations, of SnO2 nanowires deposited on Ag-covered Si substrate by vapor phase deposition (VPD), thanks to x-ray photoelectron spectroscopy (XPS) in combination with thermal desorption spectroscopy (TDS). Air-exposed SnO2 nanowires are slightly non-stoichiometric, and a huge amount of C contaminations is observed at th...

The present study examined the gas-phase photocatalytic degradation of toluene using ZnO-SnO2 nanocomposite supported on activated carbon in a photocatalytic reactor. Toluene was selected as a model pollutant from volatile organic compounds to determine the pathway of photocatalytic degradation and the factors influencing this degradation. The ZnO-SnO2 nanocomposite was synthesized through co-p...

Reserving interior void space in the cable-like structure of multiwalled carbon nanotubes-in-SnO2-in-carbon layer (MWNTs@SnO2@C) is reported for the first time. Such a design enables the structure performing excellent for Li and Na storage, which benefit from the good electrical conductivity of MWNTs and carbon layer as well as the reserved void space to accommodate the volume changes of SnO2.

Semiconducting nanoparticle tin oxide-based sensors have been prepared with a pressure load of 4, 6, 8, 10 tons and reinforced with carbon nanofibers (CNF) in SnO2 matrix. The SnO2/CNF sensor’s sensitivity for ethyl alcohol has increased by a factor of two, in compared with that of pure SnO2 8-ton pressed sensor with lower response time. These results open the way towards further optimized lowe...

We performed a comparative study of electrical and thermal properties of ZnOand SnO2-based varistor. The electrical properties of commercial ZnO-based varistor are equivalent to that found in SnO2-based varistor system. In spite of this, the SnO2 showed a thermal conductivity higher than commercial samples of ZnO-based varistor, which allied with its simpler microstructure and lower dopant conc...

This is well known that the selectivity and sensitivity of tin dioxide (SnO2) thin film sensors for the detection of low concentration of volatile sulfides such as H2S in air can be improved by small amount of Ag additives. In this paper we present the results of comparative X-ray photoelectron spectroscopy (XPS), thermal desorption spectroscopy (TDS), and atomic force microscopy (AFM) studies ...

This work presents a new route to design a highly sensitive SnO2-based sensor for acetone gas enhanced by the molecular imprinting technique. Unassisted and acetone-assisted thermal synthesis methods are used to synthesis SnO2 nanomaterials. The prepared SnO2 nanomaterials have been characterized by X-ray powder diffraction, scanning electron microscopy and N2 adsorption-desorption. Four types ...

Reducing the energy loss and retarding the carrier recombination at the interface are crucial to improve the performance of the perovskite solar cell (PSCs). However, little is known about the recombination mechanism at the interface of anode and SnO2 electron transfer layer (ETL). In this work, an ultrathin wide bandgap dielectric MgO nanolayer is incorporated between SnO2:F (FTO) electrode an...