OBJECTIVE This study tested whether the two-body wear of monolithic zirconia and their corresponding enamel antagonists was higher compared to monolithic alloy and veneered zirconia. MATERIALS AND METHODS Cylindrical specimens (N = 36, n = 6) were prepared out of (A) veneered zirconia (VZ), (B) glazed zirconia using a glaze ceramic (GZC), (C) glazed zirconia using a glaze spray (GZS), (D) man...

In this study, the integrated Taguchi-simulated annealing (SA) approach is applied to examine the wear behaviour of silicon nitride (Si3N4)hexagonal boron nitride (hBN). Wear tests for Si3N4-hBN composite versus steel (ASTM 316L) disc were carried out for a dry sliding conditions in a so-called pin-on-disc arrangement. The tests were realized at % volume of hBN 0, 4, 8, 12, 16 in Si3N4 under th...

It is well established that the total protein concentration and albumin-to-globulin ratio influence the wear of ultra-high molecular polyethylene (UHMWPE, "polyethylene") in joint prostheses. A factor on wear not yet studied, but of possible clinical relevance, is protein cleavage. Such cleavage is expected in the presence of an inflammatory response and as a result of wear processes at the art...

A major limiting factor in the longevity of total hip replacement is the wear rate of the hip bearing. As manufacturing technology has improved during the past several decades, much attention has been focused on developing newer generations of polyethylene that have lower rates of wear while minimizing free radical formation and subsequent osteolysis. The turning point for the manufacture of po...

(CAAR) is a consortium of researchers from six universities working in partnership with Department of Defense laboratories and industry. CAAR is funded by the Office of Naval Research through a 1997 Department of Research Initiative. Abstract Almost all prior work on modelling the dependance of acoustic emissions on tool wear have concentrated on the effect of wear-level on the sound. We give j...

Finding a wear law that is valid over a wide range of conditions and materials would have enormous practical value. The authors have previously iscovered a simple relationship describing the evolution of the abrasive wear rate of steel sliding against boron carbide-coated coupons, and have eveloped a model accounting for its kinetics. The authors show here that this wear equation accurately des...

Abstract— Ironically, despite the growing familiarity with composite materials and ever-increasing range of applications, use of natural fibers as reinforcement in polymeric composites for technical application has been a research subject of scientist. Pineapple leaf fibre (PALF) is one of them that have also good potential as reinforcement in polymer composite. In this present work, an experim...

This work describes the optimization of cryogenic treatment (CT) parameters such as the cooling rate, the soaking temperature, the soaking time, the tempering temperature and the tempering time to maximise the tool wear of high speed steel tools in dry turning of AISI 316 grade austenitic stainless steels by Taguchi method. For this purpose, four iteration of Taguchi design (L16) have been used...

The addition of water results in the higher wear rate of gold compared to experiments performed in the ambient environment (approximately 60% humidity). This higher wear rate in water has been observed with the AFM, Hysitron Triboindenter, and additionally in single pass scratch tests performed with the Taber Shear/Scratch tester. These tests were preformed using silicon nitride cantilevers in ...

This study explored the effects of cryogenic treatment on the microstructure, hardness, and wear-resistance of diamond-like carbon (DLC) by cryogenically treating NAK 80 mold steel coated with DLC. Raman spectroscopy analyzed the structure of the DLC film. Nanoindenter analyzed the hardness and Young’s modulus of the film, and their relationship determined the wear resistance. Wear test assesse...