The main objective of the paper is to develop a probabilistic model for capacity factor estimation for a wind turbine located in a specific area, model based on the output power distribution of wind turbine. This model was applied for a wind turbine located to a region in the North-East of Romania, the model results being validate with results from Monte-Carlo simulation. Finally, the model was...

The design of an advanced controller for wind turbine load mitigation is presented. The controller is based on Nonlinear Dynamic Inversion control methods combined with Pseudo Control Hedging to account for the actuator limits and a two degree of freedom control system for the collective pitch control of the rotor blades. The controller uses wind speed measurement information to adjust to wind ...

In a turbocharged engine, preserving the maximum amount of exhaust pulse energy for turbine operation will result in improved low end torque and engine transient response. However, the exhaust flow entering the turbine is highly unsteady, and the presence of the turbine as a restriction in the exhaust flow results in a higher pressure at the cylinder exhaust ports and consequently poor scavengi...

The modern gas turbine engine requires innovative cooling techniques to protect its internal components from the harsh operating environment typically seen downstream of the combustor. Much research has been performed on the design of these cooling techniques thus allowing for combustion temperatures higher than the melting point of the parts within the turbine. As turbine inlet temperatures an...

This paper is focusing on designing a control system for wind turbine which can control the speed and output power according to arbitrary algorithm. Reference Tracking Method is used to control the turbine spinning speed in order to increase its output energy. Keywords—Wind Turbine, Simulink, Reference Tracking Method.

Nowadays, the challenge in hydraulic turbine design is the multi-objective design of turbine runner to reach higher efficiency. The hydraulic performance of a turbine is strictly depends on runner blades shape. The present paper focuses on the application of the multi-objective optimization algorithm to the design of a small Francis turbine runner. The optimization exercise focuses on the effic...

This paper presents entropy generation minimisation model of combined heat and power system. The turbine control valves and heater throttle valves were analysed. The high-pressure control valves regulate the mass flow rate of steam into the turbine, whereas the intermediate-pressure and lowpressure control valves the steam pressure of the turbine extracts 3 and 5. The steam of the turbine extra...

The constant expansion of wind power plants and ever increasing energy needs result in a need for wind turbine installation in areas with complex terrain and highly turbulent winds. Wind turbine control during such winds is very difficult task that often cannot be efficiently accomplished by classic wind turbine control system. This paper presents a novel approach to the wind turbine control in...

Biomass is identified as one of the major renewable energy sources for electrical power generation. Heavy duty gas turbine engines are preferred for clean and efficient power generation. An extensive literature survey reveals that the governor droop setting of the heavy duty gas turbines varies from 2 percentage to 10 percentage. But it needs to be optimized for analyzing the dynamic response o...

It is now widely accepted that a shift towards renewable energy production is needed in order to avoid further anthropogenically induced climate change. The ocean provides a largely untapped source of renewable energy. As a result, harvesting electrical power from the wind and tides has sparked immense government and commercial interest but with relatively little detailed understanding of the p...