OBJECTIVE The aim of this systematic review was to investigate the influence of bone mineral density on the primary stability of dental implants. MATERIAL AND METHODS A search of health science databases (Cochrane Library, MEDLINE-PubMed, ISI Web of Knowledge, EMBASE, LILACS) and grey literature was performed, including papers published until January 2011. The main key words used were "bone d...

BACKGROUND This study evaluated the influence of implant site preparation depth on primary stability measured by insertion torque and resonance frequency analysis (RFA). MATERIAL AND METHODS Thirty-two implant sites were prepared in eight veal rib blocks. Sixteen sites were prepared using the conventional drilling sequence recommended by the manufacturer to a working depth of 10mm. The remain...

During recent decades, strain gauge-based joint torque sensors have been commonly used to provide high-fidelity torque measurements in robotics. Although measurement of joint torque/force is often required in engineering research and development, the gluing and wiring of strain gauges used as torque sensors pose difficulties during integration within the restricted space available in small join...

In this paper, we propose a new method and instruments to identify the torque, the power, and the efficiency of internal combustion engines in transient conditions. This method, in contrast to the commonly used non-demounting methods based on inertia and strain gauge dynamometers, allows controlling the main performance parameters of internal combustion engines in transient conditions without i...

Fuzzy logic is recently getting increasing emphasis in soft computing applications in the recent days. This paper presents an application of the fuzzy logic scheme to control the speed of an AC servo system & the same is proposed for a space vector pulse width modulation (SVPWM) inverter-fed permanent magnet synchronous motor (PMSM) drive. Based on the analysis of the PMSM transient response, a...

introduction: some clinicians use a handheld screw driver instead of a torque wrench to definitively tighten abutment screws. the aim of this study was to compare the removal torque of one-piece and two-piece abutments tightened with a handheld driver and a torque control ratchet. methods: 40 iti implants were placed in acrylic blocks and divided into 4 groups. in groups one and two, 10 iti one...

Stator flux oriented vector control of induction motor (IM) drives for speed sensorless control has several advantages. But the application of a pure integrator for the flux estimation is difficult due to the presence of measurement noise and dc offset. To overcome these problems, some have used a programmable cascaded low pass filter (PCLPF). In this paper, it is shown that some problems still...

PURPOSE To determine 1) the differences in maximum torque between 7 biodegradable and 2 titanium screw systems, and 2) the differences of maximum torque between "hand tight" and break of the biodegradable and the titanium osteofixation screw systems. MATERIALS AND METHODS Four oral and maxillofacial surgeons inserted 8 specimens of all 9 screw systems in polymethylmethacrylate plates. The sur...

A torque measurement system was added to a widely used hip wear simulator, the biaxial rocking motion device. With the rotary transducer, the frictional torque about the drive axis of the biaxial rocking motion mechanism was measured. The principle of measuring the torque about the vertical axis above the prosthetic joint, used earlier in commercial biaxial rocking motion simulators, was shown ...