In this paper, an improved system to efficiently utilize the low-temperature waste heat from the flue gas of coal-fired power plants is proposed based on heat cascade theory. The essence of the proposed system is that the waste heat of exhausted flue gas is not only used to preheat air for assisting coal combustion as usual but also to heat up feedwater and for low-pressure steam extraction. Ai...

Exergy analysis of an integrated molten carbonate fuel cell-turbo expander-steam turbine hybrid cycle has been presented in this study. The proposed cycle has been used as a sustainable energy approach to provide a micro hybrid power plant with high exergy efficiency. To generate electricity by the mentioned system, an externally reformed molten carbonate fuel cell located upstream of the combi...

ABSTRACT: This paper focuses on design of nonlinear power plant controller using immune based multiobjective fuzzy approach. The thermal power plant is typically regulated by the fuel flow rate, the spray flow rate, and the gas recirculation flow rate. However, Strictly maintaining the steam temperature can be difficult due to heating value variation to the fuel source, time delay changes in th...

In the Modern scenario, the naturally available resources for power generation are being depleted at an alarming rate; firstly due to wastage of power at consumer end, secondly due to inefficiency of various power system components. A Combined Cycle Gas Turbine (CCGT) integrates two cycles- Brayton cycle (Gas Turbine) and Rankine cycle (Steam Turbine) with the objective of increasing overall pl...

The steam turboset is the key equipment of the electric power system. Thus, it is very important and necessary to monitor and diagnose the running condition and the faults of the steam turboset for the safe and normal running of the electric power system. In this paper, the Internet/Intranet based remote condition monitoring and fault diagnosis scheme is proposed. The corresponding technique an...

To provide the basis for clean and affordable energy in a competitive market is the reason why integrated gasification combined cycle (IGCC) technology is currently being developed further, while the existing IGCC prototype plants have the task of proving what is technically achievable. This contribution reports interim results of a comprehensive ongoing development potential study funded by th...

The gas-steam turbine combined cycle (GTCC) is the preferred power plant type because of its high efficiency and its use of cheap and clean natural gas as fuel. It is also the preferred type in the Arab Gulf countries where it is used as cogeneration power-desalting plant (CPDP). In this chapter, descriptions and analysis of the GTCC components are presented, namely, the gas turbine cycle (comp...

Most parts of the electricity generating equipments in power plants work at elevated temperature and high steam pressure, including boiler, turbine and connected system of tubing and piping. The generating equipments operate with steam pressures in the range of 20MPa or even more and the steam temperature is also high in the range of 600 °C. This will be the condition of water and steam inside ...

conceptual design of a waste heat recovery cycle is carried out in attempt to enhance the thermal efficiency of a steam power plant. in the recovery system, super-critical an co2 is employed as the working fluid operating in a brayton cycle. low grade heat rejected by the flue gases through the stack is used as the primary heat source, while a secondary heat exchanger utilizes the hot gases lea...