aIn the present study a 4-stroke 5hp diesel engine was tested with Diesel oil plus cottonseed oil blends. The blends in different proportions (10 to 50 percent by volume) were tested at constant speed of 1500 rpm. The said engine is operated at different loads and characteristics like Brake power, Brake thermal efficiency, specific fuel consumption etc. Engine performance for blends resulted in...

Viscosity of vegetable oil is considered a constraint for its use as an alternate fuel for Internal Combustion(IC) engines. In this experimental investigation, the viscosity of cottonseed oil (CSO), which is considered a potential alternate fuel, is reduced by blending it in different proportions with diesel, and its viscosity at various temperatures was analyzed and used as a fuel in a compres...

This paper represents the prospect of mustard oil as a renewable and alternative fuel. To cope up with present load-shedding situation and to reduce the dependency on imported fuel, Bangladesh government is encouraging the use of renewable energy sources. Since diesel engines have versatile uses including small irrigation pumping systems, and standby small electricity generators, use of diesel ...

This study offers comprehensive details on the use of bio-fuel as a viable and alternative source of energy. The bio-fuel was prepared from vegetable oil, i.e., mustard oil and tested in a diesel engine in both pure form and as a diesel blend. The mustard oil blend proportions were 20%, 30%, 40% and 50% and named as bio-diesel blends B20, B30, B40 and B50. A fuel-testing laboratory determined t...

Introduction In order to overcome the pollutant emission limitations the use of homogeneous charge compression ignition (HCCI) mode must be considered in direct injection diesel engine using biodiesel fuel. HCCI mode reduces PM and NOx emissions without penalize the performances [1]. This occurs because the combustion develops with low temperature and burns a premixed air/fuel mixture. Biodiese...

Since last few years cement replacement materials with industrial by-products and agricultural wastes in concrete production are widely used. It imparts positive environmental effect because the waste materials are not released to the environment. It was reported that the leakage of motor oil onto concrete surfaces in old grinding units increased the resistance such concrete to freezing and tha...

In the study of thin film preparation using a low cost microwave induced plasma method, we have carried out calorimetric power analysis in a microwave oven with different loads. The calorimetric calibration was done with various heating loads like coconut oil, engine oil, fruit juice and water. The power consumption of water was higher when compared to other loads. The results show the comparis...

103103-0707 IJMME-IJENS © June 2010 IJENS I J E N S Abstract— The world is getting modernized and industrialized day by day. As a result vehicles and engines are increasing. But energy sources used in these engines are limited and decreasing gradually. This situation leads to seek an alternative fuel for diesel engine. Biodiesel is an alternative fuel for diesel engine. The esters of vegetables...

An experimental investigation has been carried out for the first law analysis of a DI (direct-ignition) diesel engine running on straight soybean oil (SVO) preheated at 50, 75, 100C with different loads at varying speeds of 1750, 2000, 2250 rpm. The results show that preheated straight soybean oil may be a practical replacement of the conventional diesel fuel with a small power and efficiency d...