This paper describes a 2 GHz CMOS active balanced downconversion I/Q mixer in a TSMC0.18m process for a WCDMA receiver. The mixer achieves a conversion gain of 16 dB and a double side band (DSB) NF of 13.8 dB. The mixer's IIP3 is 12.12 dBm. It consumes approximately 5 mA of current from a 1.8-V power supply. The 12.12 dBm IIP3 fulfils the UMTS requirements for a mixer design.

This paper describes a 1.5-V 5 GHz I/Q down conversion mixer in a 0.18-μm CMOS process. The mixer achieves a conversion gain of 12.7 dB within 1-dB compression point (iCP1dB) of -15.83 dBm. It also achieves a double side band (DSB) NF of 13.5 dB. The mixer's IIP3 is -5.94 dBm. The mixer consumes only 5.72 mA of current from a 1.5-V power supply. Key-Words: Analog RF-CMOS, IEEE 802.11a, IEEE 802...

In this paper, we describe the Attentional Mixer, a system that uses attention cues to selectively amplify stimuli in a user’s environment. Using a number of diffuse infrared beacons and a focused infrared receiver, the system detects head orientation and uses this information to adjust the mix of a multi-part musical piece. The simple hardware and software setup provides a new and effective wa...

Abstract This paper describes a new switching topology of a sampling mixer for SAW-less GPS (L1 band) receivers. The GPS receiver with the new mixer achieved NF 2.5dB and good blocking performance. In an alternative implementation, the mixer is stacked under a Quadrature VCO to reuse supply current. As a result, the current consumption of the GPS receiver is 11mA from 1.8V supply while maintain...

A linearity improvement technique for a common-source transconductance stage is proposed. The proposed technique requires an additional MIM capacitor located in parallel with the intrinsic gate-source capacitor of a transistor. The origin of the linearity improvement is explained and the proposed technique is applied to a down-conversion mixer. From the simulation, the down-conversion mixer tha...

The impedance of the superconducting hot-electron bolometer mixer was measured in the range 0.2-4 GHz. A special technique relying on determination of the Sz, transmission parameter of the device was used. Many advantages of the technique (wide frequency range, in situ calibration, low test power, accuracy) are demonstrated. The estimate of the mixer bandwidth from the impedance data using the ...

To achieve high mixing efficiency in microfluidic devices, complex designs are often required. Microfluidic devices have been evaluated with light and confocal microscopy, but fluid-flow characteristics at different depths are difficult to separate from the en face images produced. By using optical coherence tomography (OCT), an imaging modality capable of imaging 3D microstructures at micromet...

In this paper, we describe the design, fabrication, and the performance of a low-noise dual-polarized quasi-optical superconductor–insulator–superconductor (SIS) mixer at 550 GHz. The mixer utilizes a novel cross-slot antenna on a hyperhemispherical substrate lens, two junction tuning circuits, niobium trilayer junctions, and an IF circuit containing a lumped element 180 hybrid. The antenna con...