there are many parameters that affect the sheet hydroforming process such as fluid pressure, material properties, interfacial friction between blank and tool surfaces, etc. in this paper, a fem-based taguchi method is used to determine the effects of forming parameters on the quality of part formability in the process of hydrodynamic deep drawing assisted by radial pressure. four important form...

Die corner filling is very important in tube hydroforming process. Definition of the internal pressure path is a key factor in improving the corner filling.  However, the factors that cause improvement of corner filling are still unclear. In this paper, effect of bilinear pressure path on corner filling in hydroforming of tube in box-shape die is studied using both finite element simulation and...

In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...

Introduction: Human identification plays a vital role in any crime investigation. Along with the various other established methods, cheiloscopy also plays a key role in linking the criminal with the crime. The ability of a technique in differentiating the sex of a person in the field can help in screening a large number of suspects. This study evaluated the efficacy of cheiloscopy in determinat...

Comparing the today’s situation to the last ISPRS congress, where the very first commercial digital large format airborne sensors ADS40 (Leica Geosystems) line scanner and DMC (ZI-Imaging now Intergraph) frame based camera were launched into the market, an increase in number of new digital airborne sensors (some of them already introduced into operational use) is clearly obvious over the last 4...

The aim of the present study is to determine the feasibility of making a rectangular twist waveguide used to rotate electromagnetic waves. For this purpose, the process of fabricating an aluminum rectangular twist waveguide was simulated by making use of finite element method and Deform software. The optimum length and angle of the twist die for manufacturing a twist waveguide with inner cross ...

Micro-stamping process is one of the most cost-effective methods to manufacture metallic bipolar plates (BPPs). This research investigates the forming of titanium thin sheet as a potential candidate for BPPs in proton exchange membrane fuel cell (PEMFC). In this regard, the process was first simulated using finite element (FE) code Abaqus. Afterward, experimental tests were implemented and the ...

We consider accretion disks consisting of counter-rotating gaseous components with an intervening shear layer. Configurations of this type may arise from the accretion of newly supplied counter-rotating gas onto an existing co-rotating gas disk. For simplicity we consider the case where the gas well above the disk midplane is rotating with angular rate +Ω and that well below has the same proper...