Abstract This paper studies the characteristics of insulation shear belt produced by fracture vents gunhead desceptor and reasons for its formation when shell is fired. The results show that: During explosion, rupture degenerator belongs to ligament fracture, at time break plays role “prefabricated crack”. smaller microstructure grain alloy steel, easier it promote production belt.

Due to the different properties of materials, fusion welding dissimilar metals may be difficult. Structural irregularities form as a result various phase transformations during welding. Solid-state welding, opposed occurs below melting temperature. As and solidification phenomena that happen in solid-state is expected reduce potential for transformation. This paper describes use rotary friction...

introduction: the purpose of this in vitro study was to compare working length (wl) changes after straight-line access (sla) and different coronal flaring (cf) methods. materials and methods: coronal access preparations were made (without sla) in molar teeth to allow access to 120 canal orifices with a hand file. the suitable cusp and root tips were then flattened to facilitate reproducible and...

Abstract—The connecting rod transmits the piston load to the crank causing the latter to turn, thus converting the reciprocating motion of the piston into a rotary motion of the crankshaft. Connecting rods are subjected to forces generated by mass and fuel combustion. This study investigates and compares the fatigue behavior of forged steel, powder forged and ASTM a 514 steel cold quenched conn...

A three-dimensional (3D) finite element (FE) model is applied to predict the temperature evolution in the laser welding of galvanized high-strength steels in a zero-gap lap joint configuration. A rotary Gaussian volumetric heat source model is introduced to simulate the laser energy input. The temperature data measured by thermocouples are used to verify the boundary conditions of the thermal m...

Introduction: Lateral condensation effectiveness may be influenced by the gutta-percha and finger spreader taper used during root canal obturation. Objective: To evaluate the penetration ability of finger spreader into simulated root canals prepared using MTwo rotary system and filled with different gutta-percha and finger spreader tapers. Material and methods: Resin blocks with curved root can...

A self-developed rotary multi-cutter device cuts stainless steel wire ropes into segments to fabricate twisted wires. Stainless steel porous twisted wire materials (PTWMs) with a spatial composite intertexture structure are produced by the compaction and subsequent vacuum solid-phase sintering of twisted wires. The stainless steel PTWMs show two types of typical uniaxial tensile failure modes, ...