A. Kmita, AGH University of Science and Technology, Academic Centre for Materials and Nanotechnology, Krakow, Poland. J. Zych, M. Holtzer, J. Mocek, AGH University of Science and Technology, Faculty of Foundry Engineering, Krakow, Poland. S. Piasny, Engineering Enterprise HARDKOP, Trzebinia, Poland. The aim of the investigations was the development of the protective coating and the method of it...

The protective performance of zeolite coating on AZ91D magnesium alloy was evaluated using potentiodynamic polarisation and electrochemical impedance spectroscopy (EIS) in 0.1 M sodium chloride solution (NaCl). Electrical equivalent circuit (EEC) was developed based upon hypothetical corrosion mechanisms and simulated to correspond to the experimental data. The morphology and the chemical natur...

T his inspection by the Occupational Safety and Health Administration (OSHA) reports on an overexposure to methylene bisphenyl isocyanate (MDI) during the spray application of a protective coating for truck beds. The inspection was conducted at an autobody repair shop and collision center that also operated a spray-on truck bed coating operation. The investigation was initiated as a complaint i...

Welding processes are one of the most widely spread industrial activities, and their quality control is an important area of research. The presence of residual traces from the protective antioxidant coating, is a problematic issue since it causes a significant reduction in the welding seam strength. In this work, a solution based on a Laser Induced Breakdown Spectroscopy (LIBS) setup and a Supp...

We present a method to increase the stability of DNA nanostructure templates through conformal coating with a nanometer-thin protective inorganic oxide layer created using atomic layer deposition (ALD). DNA nanotubes and origami triangles were coated with ca. 2 nm to ca. 20 nm of Al2O3. Nanoscale features of the DNA nanostructures were preserved after the ALD coating and the patterns are resist...

Thin-film coating plays a prominent role on the manufacture of many industrial devices. Coating can increase material performance due to the deposition process. Having adequate and precise model that can predict the hardness of PVD and CVD processes is so helpful for manufacturers and engineers to choose suitable parameters in order to obtain the best hardness and decreasing cost and time of in...

This paper reports for the first time the use of perovskite bismuth ferrite (BiFeO3 or BFO) on ZnO-based solid state solar cells using only chemical solution methods for materials synthesis. As ZnO has poor chemical stability in acidic and corrosive environments, a buffer method using aminosilane ((3-aminopropyltriethoxysilane or H2N(CH2)3Si(OC2H5)3)) coating was used to provide a protective co...

A new technique was accepted to fill the porosity of Al coating applied by arc thermal spray process to enhance corrosion resistance performance in artificial ocean water. The porosity is the inherent property of arc thermal spray coating process. In this study, applied coating was treated with different concentrations of ammonium phosphate mono basic (NH4H2PO4: AP) solution thereafter dried at...

INTRODUCTION: Magnesium alloys are attractive as a class of biodegradable metallic materials. However, too fast degradation is an obstacle to their clinical applications. Recently, micro-arc oxidation (MAO) coatings were applied on biodegradable magnesium alloys to delay their degradation. In vivo studies showed that the protective ability of the MAO coating should be further improved [1]. Seal...

A ship building grade of carbon steel has been coated with copper by a furnace brazing process starting from a brass braze. An argon protective atmosphere was used to prevent oxidation of the steel. However, when the deposit was produced a low gas flow rate ensured that zinc was lost from the brass by oxidation leaving a copper deposit on the steel surface. The copper was found to be zinc free ...