A square splittered and unsplittered rod is placed in a turbulent boundary layer developed over a flat plate. The effect of the resulting disturbances on the local heat transfer coefficient is then studied. In both cases the square rod modifies the flow structure inside the boundary layer. As a result, a stagnation point, a jet and wake area are generated around the square rod, each making a co...

introduction: frying phenomena occur during the immersion of the product in oil at a temperature of 150–200 ºc, where a simultaneous heat and mass transfer take place. this is the most popular thermal processes of potato cooking. this fast drying is critical to improve the mechanical and structural properties of the final product. these conditions lead to high heat transfer rates, rapid cooking...

An experimental investigation was carried out to study mixed convection heat transfer from Al2O3-water nanofluid inside a vertical, W-shaped, copper-tube with uniform wall temperature. The tests covered different ranges of some involved parameters including Reynolds number, temperature and particles volume fraction. The results showed that the rate of heat transfer coefficient improved with Rey...

The present study investigated the effect of distilled-water/ silver nanofluid on heat transfer in a closed cooling system of one of the electrical energy generation units at Isfahan power plant. The difference between this study and previous researches refers to silver properties which have a high thermal conductivity and is non-toxic, hydrophilic and eco-friendly. Distilled water/ silver ...

nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. in this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in pure ...

in this study, thermal performance of a cylindrical heat pipe is investigated numerically. three different types of water based nanofluids, namely (al2o3+water), (diamond+water) and (multi-wall carbon nano tube (mwcnt) +water) have been used. the influence of using the simple nanofluids and mwcnt nanofluid on the heat pipe characteristics such as liquid velocity, pressure profile, temperature p...

a down-flow hanging sponge (dhs) reactor has been developed for sewage treatment, mainly in developing countries. this novel reactor employs polyurethane sponge material as a support medium, which promises a proliferation of a large amount of biomass, offering excellent pollutant removal capability. three types of sponge medium were evaluated with respect to water distribution and oxygen mass t...

An experimental investigation was conducted to study the average and the fully-developed heat (mass) transfer coefficients in a rectangular smooth duct and a duct with repeated-baffle blockages. The focus of attention in this work is the conventional correlation Nu / Nufd 1 + C / ( X / D ) for the average heat transfer coefficient. It was shown that for relatively short ducts, the coefficient C...

the performance of a γ-al 2 o 3 /n-decane nanofluid shell-and-tube heat exchanger in a biomass heating plant is analyzed to specify the optimum condition based on the maximum heat transfer rate and performance index for wide range of nanoparticle volume fraction (0–7%). compared with pure          n-decane, the obtained results in this research show that by using γ-al 2 o 3 /n-decane nanofluid ...