The aim of this investigation was to evaluate the metal-ceramic bonding of Au-1.6 wt% Ti alloy. Therefore, the coefficient of thermal expansion, modulus of elasticity, ceramic bonding strength, and hardness of Au-1.6 wt% Ti alloy were measured. The metal-ceramic interface was observed by EPMA to investigate its bonding mechanism. The Au-1.6 wt% Ti alloy showed a coefficient of thermal expansion...

The success of metal-ceramic restorations depends on an optimal bond between metal and ceramic. This study evaluated the effect of 3 casting atmospheres on the metal-ceramic bond strength (MCBS) of 2 Ni-Cr alloys, with beryllium (Fit Cast V) and without beryllium (Fit Cast SB). Sixty acrylic resin patterns (8 mm long and 5 mm diameter) were obtained using a fluorocarbon resin matrix. Wax was us...

Nine 35% Ag-30% Pd-20% Au-15% Cu alloys containing 2, 4 and 6 mass% of Sn, Ga or In as an additive metal were experimentally prepared to investigate the effects of different additives and their content on the physical and mechanical properties as well as the bond with a ultra-low fusing ceramic. Both the different additives and their content or either of these two factors significantly influenc...

Introduction: The process of mixing metals with non metals is called alloying, and the resulting mixture alloy. Alloys are composed of at least two elements, from which one must be metal. They are divided into alloys for fixed partial dentures-FPD (golden, golden-platinum, silver-palladium alloys, alloys for soldering and alloys for metal-ceramic dentures). Purpose: the main purpose is to inves...

AIM The aim of this study was to evaluate the effect of recasting base metal alloy on the metal-ceramic bond strength. MATERIALS AND METHODS A total of 60 test samples were prepared from new and recast nickel-chromium alloy and divided into six groups. In group A0, test samples were prepared from 100% new alloy. Groups A1, A2, A3, A4, and A5 were prepared from 50% new alloy and 50% casting re...

statement of problem: recent clinical results for zirconia all-ceramic restorations have revealed that the fracture rate 6-15% of the zirconia framework is so low and the core of zirconia has high stability. however, chipping-off fractures of porcelain are the most common reason for failures of zirconia in the fixed partial dentures. objectives: the purpose of this study was to compare the shea...

Nanocrystals have drawn lots of attention in many fields. The main-stream synthetic routes usually produced hydrophobic nanocrystals (NCs). Organometallic precursors and long-alkyl-chain ligands are adopted and for further use surface modification to render them water-soluble is needed. A direct protocol to synthesize water-soluble NCs in an environmental-friendly and convenient way is still qu...

Aluminium metal matrix composites are widely used in engineering applications, specially automobile, aerospace, marine and mineral processing industries owing to their improved wear properties compared to conventional monolithic aluminium alloys. Presently hybrid composites plays vital role in engineering application. The researchers who developed composites, were subjected to many characterisa...

In this review article, the fundamentals of electrochemical reactions involving metal hydrides are explained, followed by a report of recent progress in hydrogen storage alloys for electrochemical applications. The status of various alloy systems, including AB₅, AB₂, A₂B₇-type, Ti-Ni-based, Mg-Ni-based, BCC, and Zr-Ni-based metal hydride alloys, for their most important electrochemical applicat...

The continuous technological advance and increasing availability of new base metal alloys and ceramic systems in the market, coupled to the demands of daily clinical practice, have made the constant evaluation of the bond strength of metal/porcelain combinations necessary. This study evaluated the metal/porcelain shear bond strength of three ceramic systems (Duceram, Williams and Noritake) in c...