Weld area and weld depth/width ratio can be considered to be of the most important geometrical factors in pulsed laser welding. The effects of carbon dioxide and oxygen additions to the argon shielding gas on the weld properties in pulsed laser welding of low carbon steel is investigated. Presence of carbon dioxide and oxygen up to 10 and 15 percent respectively decreases the weld geometrical f...

Medium-carbon steel is commonly used for the rail, wire ropes, tire cord, cold heading, forging steels, cold finished steel bars, machinable steel and so on. Its fatigue behavior analysis and fatigue life estimation play an important role in the machinery industry. In this paper, the estimation of fatigue life of medium-carbon steel with different surface roughness using established S-N and P-S...

In this paper, an ultra low carbon High Strength Low Alloy Grade Steel was subjected to a two-step forging process and this was followed by different post cooling methods. The highest strength was obtained at a faster cooling rate due to the highly dislocated acicular ferrite structure with the fine precipitation of microalloying carbides and carbonitrides. At a slow cooling rate, the strength ...

OBJECTIVES A comparative study on the stress distribution in the dentine and cement layer of an endodontically treated maxillary incisor has been carried out by using Finite Element Analysis (FEA). The role of post and cement rigidity on reliability of endodontic restorations is discussed. METHODS A 3D FEM model (13,272 elements and 15,152 nodes) of a central maxillary incisor is presented. A...

structural steels with very high strength levels are often referred to as ultrahigh-strength steels (uhss). the usage of uhss has been extensively studied in aerospace industries and offshore platforms. in this study, medium carbon low alloy steel (ams6305) was thermomechanicaly treated to obtain an ultra-high strength bainitic steel for aircraft engine compressor disk. a novel themomechanical ...

The study systematically compares the low-cycle fatigue (LCF) behaviors of novel martensitic steel (22MnSi2CrMoNi) and maraging (00Ni18Co9Mo4Ti). Results show that two types tested have a similar cyclic deformation behavior. softening resistance 22MnSi2CrMoNi is slightly inferior to 00Ni18Co9Mo4Ti at low total strain amplitude. However, gap gradually disappears with increase At same plastic amp...

This paper reports on the precipitation behaviour and microstructural evolution in ~20% cold rolled NbMoV and V single microalloyed low carbon steels during intercritical annealing. The microstructure and precipitation behaviour were studied by optical and scanning/transmission electron microscopy and microanalysis, X-ray diffraction technique and Vickers hardness testing. After intercritical a...

The life of a concrete bridge exposed to deicing salt or seawater has often been limited by corrosion of the steel reinforcement. The service life of a concrete structure, degraded by corrosion, is considered to be the sum of the initiation and propagation periods. The initiation phase is the time required for sufficient accumulation of aggressive species at the rebar surface to initiate corros...

Calculations verify that carbon diffusion may occur during the lath martensite fomtion. Accordingly,the diffusion of int2rstitial ator ions must be taka into account nhfn martmitic transformtion is defined as a diffusionless transformation. In derivation of the kinetics equation of the ath& martensitic transfomtion,rzgardng the c a r h diffusion, i .e.the enrichment of the austenite during the ...