Biosolids are a byproduct of wastewater treatment and contain organic and inorganic materials removed from the wastewater. These residuals are concentrated by various methods to semi-solid form. Likewise, sludge is generated during water treatment and contains solid materials removed from water as well as chemicals added during the treatment process. The final residual water content depends on ...

Hospital effluents represent an important source for the release of antibiotics and antibiotic resistant bacteria into the environment. This study aims to determine concentrations of various antibiotics in wastewater before and after wastewater treatment in a rural hospital (60 km from the center of Hanoi) and in an urban hospital (in the center of Hanoi) in Vietnam, and it aims to explore the ...

A shaft-type activated sludge reactor has been developed in order to study the feasibility of high-rate wastewater treatment. The reactor having volume of about 14.5 L was operated with the acclimated mixed activated sludge under batch and continuous mode using a synthetic wastewater as feed. The batch study was performed with varying chemical oxygen demand (COD) concentrations of 1000–3500 mg·...

BACKGROUND Environmental Health Indicators (EHIs) are the most important criteria for evaluation of efficiency and effectiveness of the activities of the health sector. The operations and situation of the health system can be analyzed through surveying the indicators and comparing them during different times. The present study aimed to study the EHIs of Tabriz, using the common environmental he...

This study focused on the diversity of bacterial communities from two series of two-stage constructed wetlands (CWs) treating tannery wastewater, under different hydraulic conditions. Series were separately planted with Typha latifolia and Phragmites australis in expanded clay aggregates and operated for 31 months. The effect of plant species, hydraulic loading and unit stage on bacterial commu...

BACKGROUND The aim of this study was to determine the potential of produced compost from the sludge of wastewater treatment plant using earthworms and compare it with the vermicompost produced from household solid waste. METHODS In the current study, three treatments with the same conditions in terms of organic wastes type were prepared to produce vermicompost from household solid waste and s...

It has been reported that bacteria-mediated degradation of contaminants is a practical and innocuous wastewater treatment. In addition, iron oxide nanoparticles (NP) are wastewater remediation agents with great potentials due to their strong adsorption capacity, chemical inertness and superparamagnetism. Therefore, a combination of NPs and microbes could produce a very desirable alternative to ...

A two fluid model (TFM) was used to study gas-solid heat transfer in a riser with different inclination angles. A two dimensional pipe with 5.8 cm internal diameter and 5 meter length was chosen.  Effect of bed angle and solid particles feed rate were studied on the heat transfer behavior of gas and solid particles. Obtained results from simulation are compared with the experimental data in the...

Microbial fuel cell (MFC) technology provides a low cost alternative to conventional aerated wastewater treatment, however, there has been little comparison between MFC and aeration treatment using real wastewater as the substrate. This study attempts to directly compare the wastewater treatment efficiency and energy consumption and generation among three reactor systems-a traditional aeration ...

This study was to evaluate the feasibility of recycling the solids separated from swine wastewater treatment process as a fuel source for heat production and to provide a data set on the gas emissions and combustion properties. Also, in this study, the heavy metals in ash content were analyzed for its possible use as a fertilizer. Proximate analysis of the solid recovered from the swine wastewa...