We report phase-conjugate feedback into a fluorozirconate optical fiber amplifier at infrared wavelengths. By using a semiconductor laser diode at 807 nm, a grating is established in photorefractive BaTiO(3) that, in the ring configuration, provides feedback into the amplifier necessary for laser action. Once written, the grating is self-sustaining, and lasing is observed even after the laser d...

Amplification and simultaneous phase regeneration of DPSK signals is demonstrated using a phase-sensitive amplifier. Phase-sensitive gain is achieved in a Sagnac fiber interferometer comprised of nonpolarization maintaining, highly nonlinear fiber operating in the un-depleted pump regime. Both the pump and signal are RZ-DPSK pulse trains. The amplifier is capable of producing greater than 13 dB...

We demonstrate a multistage erbium fiber amplifier seeded by a gain-switched laser diode operating at a wavelength of 1550 nm and a repetition rate of 1 MHz. The pulse energy is 0.5 μJ, and the pulse duration is 40 ps, resulting in a peak power of 11.4 kW. The three-stage all-fiber amplifier system is designed to avoid any spectral distortions induced by gain saturation or nonlinear effects and...

We report the generation of up to 0.7 mW of narrow-linewidth (<60-MHz) radiation at 3.3 micrometers by difference frequency mixing of a Nd:YAG-seeded 1.6-W Yb fiber amplifier and a 1.5-micrometers diode-laser-seeded 0.6-W Er/Yb fiber amplifier in periodically poled LiNbO3. A conversion efficiency of 0.09%/W (0.47 mWW-2 cm-1) was achieved. A room-air CH4 spectrum acquired with a compact 80-m mul...

We experimentally demonstrate generation of bright sub-Poissonian light by means of parametric deamplification in a phase-sensitive fiber amplifier that is based on a balanced nonlinear Sagnac interferometer. On direct detection, the photocurrent noise falls below the shot-noise limit by (0.6 +/- 0.2) dB (1.4 dB when corrected for detection losses). To observe the noise reduction we employed a ...

We investigate the energy optimization (minimization) for amplified links. We show that using the using a well-established analytic nonlinear signal-to-noise ratio noise model that for a simple amplifier model there are very clear, fiber independent, amplifier gains which minimize the total energy requirement. With a generalized amplifier model we establish the spacing for the optimum power per...

We show, using nonlinearity management, that the optimal performance in high-bit-rate dispersion-managed fiber systems with hybrid amplification is achieved for a specific amplifier spacing that is different from the asymptotically vanishing length corresponding to ideally distributed amplification [Opt. Lett. 15, 1064 (1990)]. In particular, we prove the existence of a nontrivial optimal span ...

This paper proposes a new design methodology for discrete multi-pumped Raman amplifier. In a multi-objective optimization scenario, in a first step the whole solution-space is inspected by a CW analytical formulation. Then, the most promising solutions are fully investigated by a rigorous numerical treatment and the Raman amplification performance is thus determined by the combination of analyt...

Also the optical fiber amplifiers FAs that amplify weak signals such as the. Rare-Earth-Doped Fiber Lasers and Amplifiers, Michael J.F.Chapter 2. Optical and Electronic Properties of Rare Earth Ions in Glasses William J Miniscalco Abstract-HiRes PDF 2316 KB-PDF wlinks 2330 KB.amplifier materials in the system of rare-earth doped glasses are presented. rare-earth-doped ram concept manual pdf fib...