When subjected to alternating stresses, most materials degrade, e.g., suffer premature failure, due to a phenomenon known as fatigue. It is generally accepted that in brittle materials, such as ceramics, cyclic fatigue can only take place where there is some degree of toughening, implying that premature fatigue failure would not be expected in polycrystalline silicon where such toughening is ab...

Fatigue failures caused by cyclic stresses are commonly modeled by Birnbaum-Saunders (B-S) and Weibull distributions. Sometimes, materials with high cycle fatigue exhibit bimodal failure rates which are difficult to model with Weibull distribution. The objective of this paper is to investigate a general Birnbaum-Saunders (GB-S) distribution which covers diverse hazard rates such as increasing, ...

AIM To compare the cyclic fatigue resistance of HyFlex CM, Twisted Files (TF), K3XF, Race, and K3, and evaluate the effect of autoclave sterilization on the cyclic fatigue resistance of these instruments both before and after the files were cycled. METHODOLOGY Five types of NiTi instruments with similar size 30, .06 taper were selected: HyFlex CM, TF, K3XF, Race and K3. Files were tested in a...

1 ATE-80212044©Asian-Transactions September 2012 Study the Effect of Welding Joint Location on the Fatigue Strength and Fatigue Life for Steel Weldment Dr.Ali Sadiq Yasir Kufa University / Faculty of Engineering Mechanical Engineering Department IRAQ E-mail:[email protected] / [email protected] Abstract: The welding process is one of the oldest joining processes between the ma...

Objectives It was aimed to compare the cyclic fatigue resistances of ProTaper Universal (PTU), ProTaper Next (PTN), and ProTaper Gold (PTG) and the effects of sterilization by autoclave on the cyclic fatigue life of nickel-titanium (NiTi) instruments. Materials and Methods Eighty PTU, 80 PTN, and 80 PTG were included to the present study. Files were tested in a simulated canal. Each brand of ...

Introduction Achilles tendon ruptures occur frequently and result in significant pain and disability with extensive recovery time. Since the Achilles tendon experiences repetitive loads at or near failure during normal activity, knowledge of tendon fatigue properties is critical for determining when patients may resume normal activity. Several studies have suggested the benefits of fatigue test...

The strength and fatigue behavior of bulk fused silica is well understood in terms of the growth of microcracks under the combined influence of stress and environmental attack. The behavior of high strength, flaw free silica optical fiber shows significant differences from the bulk material for poorly understood reasons making long term predictions unreliable. It is known that silica fiber stre...

Nowadays, the human error is usually identified as the conclusive cause of investigations in road accidents. The human although is the person in control of vehicle until the moment of crash but it has to be understood that the human is under continued impact by various factors including road environment, vehicle and human’s state, abilities and conduct. The current advances in design of vehicle...