Micro-electrochemical additive manufacturing (μECAM) is reverse of electrochemical micro-machining (μECM) which used for selective and localized deposition material on a substrate. It can be to manufacture small sized parts or deposit functional metal coatings conductive surfaces. As the process contactless generates negligible joule heating, deposited free from heat affected zones has low inte...

The study of interactions of jet into cross flow at different longitudinal and transverse angles of jet was studied. The following components were designed and constructed: a low velocity wind tunnel to produce the uniform flow, a flat plate with a traverse injection system to simulate the jet injection, and a spatial rake to measure the total pressure. The tests were carried out at longitudina...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

numerical study has been carried out for slot air jet impingement cooling of horizontal concentric circular cylinders. the slot air jet is situated at the symmetry line of a horizontal cylinder along the gravity vector and impinges to the bottom of the outer cylinder which is designated as θ=0°. the outer cylinder is partially opened at the top with width of w=30mm and is kept at constant tempe...

In this study, we report poly(1H-thieno[3,4-d]imidazol-2(3H)-one) (pTIO) derivatives for an electrochromic (EC) type e-paper and its novel printing fabrication process. pTIO is a kind of conductive polymer (CP) s which are known as one of the EC materials. The electrochromism of pTIO is unique, because its color in doped state is almost transparent (pale gray). A transparent state is required t...

introduction jet stream is strong narrow current concentrated by strong vertical and lateral wind shears (vasantha et al, 2002). according to world meteorological organization nomenclature, jet stream formed when the speed of wind greater than 60 knots or 30 m/s. the major characteristics of the troposphere and lower stratosphere in the vicinity of jet streams were pointed out by a group of met...

Nontraditional manufacturing (NTM) is becoming increasingly important in modern engineering. Therefore, it is important to develop up-to-date pedagogic materials for the area. This paper reports collaborative efforts among three universities in such a development sponsored by National Science Foundation of USA. The features of the development include systematic introduction, recent research res...

Electrochemical Capacitance of Serpentinizing Hydrothermal Systems Steve Vance Jet Propulsion Laboratory, Caltech, MS 183-401, 4800 Oak Grove Dr., Pasadena, CA 91024 ([email protected]) Differentiated icy satellites and dwarf planets in the size range R ≈ 250− 2000 km constitute a special class of objects sufficiently large for anhydrous and chemically reducing rocky interiors to result from ...