Finding the collapse susceptible portion of a power system is one of the purposes of voltage stability analysis. This part which is a voltage control area is called the voltage weak area. Determining the weak area and adjecent voltage control areas has special importance in the improvement of voltage stability. Designing an on-line corrective control requires the voltage weak area to be determi...

Finding the collapse susceptible portion of a power system is one of the purposes of voltage stability analysis. This part which is a voltage control area is called the voltage weak area. Determining the weak area and adjecent voltage control areas has special importance in the improvement of voltage stability. Designing an on-line corrective control requires the voltage weak area to be determi...

This paper presents a new centralized adaptive method under frequency load shedding. Sometimes, after initial frequency drop following severe disturbances, although the system frequency returns to its permissible value, however, the system might become unstable due to voltage problems. In this regard, the paper proposes a new centralized adaptive load shedding method to enhance the voltage stab...

A large-scale power grid's ability to transfer energy from producers to consumers is constrained by both the network structure and the nonlinear physics of power flow. Violations of these constraints have been observed to result in voltage collapse blackouts, where nodal voltages slowly decline before precipitously falling. However, methods to test for voltage collapse are dominantly simulation...

Abstract— In order to meet the demand of the signal test device of phase-sensitive, by modeling and simulating on the transient stability and load change resistance, the control stability of variable frequency power is increased with parameter configuration, increased phase margin and amplitude margin. Besides, using ARM embedded kernel control chip the dual variable frequency power is establis...

This paper presents the analysis of dynamic noise margin of proposed 8T static random access memory (SRAM) cell. The proposed SRAM cell has two voltage sources, one connected to the bit line and the other is connected to bitbar line. These voltage sources are used to reduce the swing voltage at the output nodes. This reduction of swing voltage causes the reduction in dynamic power dissipation o...

The design of voltage regulators for mobile computing applications is complicated by several factors that lead to making tradeoffs between efficiency, voltage ripple and dynamic response. Careful choices must be made in selecting the passive and active components order to accommodate for the performance figures required to achieve compatibility for DVS ready processors. A suitable control schem...

Voltage instability is one phenomenon that could happen in power system due to its stressed condition. The result would be the occurrence of voltage collapse which leads to total blackout to the whole system. Therefore voltage collapse prediction is important in power system planning and operation. Line outage in power system could also lead to the event of voltage collapse which implies the co...

This article describes the methodology for evaluation of the reliability of an composite electrical power system considering voltage stability and continuation power flow, which takes into account the peak load and steady state stability limit. The voltage stability is obtained for the probable outage of transmission lines and removal of generators along with the combined state probabilities. T...

This study examines a new approach to selecting the locations of unified power flow controllers (UPFCs) in power system networks based on a dynamic analysis of voltage stability. Power system voltage stability indices (VSIs) including the line stability index (LQP), the voltage collapse proximity indicator (VCPI), and the line stability index (Lmn) are employed to identify the most suitable loc...