1 Associate Research Fellow,Center for Research on Earthquake Engineering (NCREE), Chinese Taiwan 2 Professor, Dept. of Civil Engineering, Taiwan University, Taipei, Chinese Taiwan 3 Assistant Professor, Dept. of Civil and Environmental Engineering, University of Kaohsiung, Kaohsiung, Chinese Taiwan Email: [email protected] ABSTRACT : Ductility is the main attribute of steel moment connections...

This paper reports a new technique that combines the features of Accumulative Roll Bonding (ARB) and Asymmetric Rolling (AR). This technique has been developed to enable production of ultra-thin bimetallic foils. Initially, 1.5 mm thick AA1050 and AA6061 foils were roll-bonded using ARB at 200°C, with 50% reduction. The resulting 1.5 mm bimetallic foil was subsequently thinned to 0.04 mm throug...

in the conventional design and analysis methods affecting parameters (loads, materials'strength, etc) are not set as probable variables. safety factors in the current codes andstandards are usually obtained on the basis of judgment and experience, which may beimproper or uneconomical. in technical literature, a method based on nonlinear static analysisis suggested to set reliability index on st...

The engineering tension test is widely used to provide basic design information on the strength of materials and as an acceptance test for the specification of materials. In the tension test a specimen is subjected to a continually increasing uniaxial tensile force while simultaneous observations are made of the elongation of the specimen. The parameters, which are used to describe the stress-s...

We report a strategy to significantly improve the ductility and achieve large superelastic and shape memory strains in polycrystalline Cu–Al–Ni shape memory alloys that are normally brittle. We use a liquid-phase Taylor wire forming process to obtain microwires of 10–150 m diameter with a bamboo grain structure. The reduction of grain boundary area, removal of triple junctions, and introduction...

Abstract The building sector benefits from high-strength lightweight concrete (HSLWC) in various aspects, particularly reducing the structure’s dead load. Incorporating waste materials into HSLWC encourages sustainable practices, reduces their environmental effect, and decreases product’s costs. This research focuses on producing using a pumice stone additive such as sugar molasses, silica fume...

FINAL REPORT Background and Motivation There is a need for lightweight structural materials for transportation to improve the performance and energy efficiency. Because magnesium (Mg) is 36% less dense than aluminum (Al) (1.74 g/cm for Mg vs. 2.70 g/cm for Al), Mg-based alloys have received increasing attention lately. The limiting property of Mg and its alloys at the present time is poor ducti...

the quenching and partitioning (q&p;) process is a new heat treatment cycle to produce the third generation of advanced high strength steels based on diffusion of carbon from martensite to retained austenite phase. the application of this process for various steels leads to a remarkable combination of mechanical properties including high strength and good ductility. using this process in automo...