address correspondence to: Dr. Victor Pantojas, Math-Physics Department, Universidad de Puerto Rico en cayey, 205 ave. antonio R. Barceló, cayey, PR 00736. Tel: (787) 738 2162 ext. 3257 • E-mail: [email protected] Scaffolds composed of a mixture of poly (L-lactic) acid (PLLA) and polyethylene glycol (PEG) biodegradable polymers were prepared by electrospinning. Threedimensional scaffolds ...

The ZnO:Al thin films were prepared by RF magnetron sputtering on Si substrate using Pt as interdigitated electrodes. The structure was characterized by XRD and SEM analyses, and the ethanol vapor gas sensing as well as electrical properties have been investigated and discussed. The gas sensing results show that the sensitivity for detecting 400 ppm ethanol vapor was ~20 at an operating tempera...

Using a combinatorial approach, Cr, Al and C have been deposited onto sapphire wafer substrates by High Power Impulse Magnetron Sputtering (HiPIMS) and DC magnetron sputtering. X-ray photoelectron spectroscopy, X-ray absorption spectroscopy and X-ray diffraction were employed to determine the composition and microstructure of the coatings and confirm the presence of the Cr2AlC MAX phase within ...

We describe the magnetron sputtering deposition of thin films at oblique angles. A general relation between the deposition rate of the film and experimental parameters such as gas pressure or substrate tilt angle is deduced and experimentally tested. The model also permits the direct determination of the thermalization mean free path of the sputtered particles in the plasma gas, a key magnitude...

Amorphous carbon films are deposited employing high power impulse magnetron sputtering (HiPIMS) at pulsing frequencies of 250 Hz and 1 kHz. Films are also deposited by direct current magnetron sputtering (dcMS), for reference. In both HiPIMS and dcMS cases, unipolar pulsed negative bias voltages up to 150 V are applied to the substrate to tune the energy of the positively charged ions that bomb...

Dependence of the phase and magnitude of the response of MgO substrate YBa2Cu3O7 d (YBCO) transition edge bolometers to the near infrared radiation on the superconducting transition width is presented in this work. The bolometers were made of YBCO thin films of 200 nm thickness that were grown on single crystal MgO (100) substrates by DC inverted cylindrical magnetron sputtering. We have measur...

In this paper, a magnetron memristor model based on hyperbolic sine function is presented and the correctness proved by studying the trajectory of its voltage and current phase, and then a memristor chaotic system with the memristor model is presented. The phase trajectories and the bifurcation diagrams and Lyapunov exponent spectrum of the magnetron memristor system are plotted by numerical si...

Microstructural features of sputtered chromium and chromium-50 wt. % platinum thin films on carbon substrates are presented. Films produced by rf sputtering and dc magnetron sputtering are compared using analytical electron microscopy techniques. All rf-sputtered films are uniform in chemistry and thickness and are amorphous. The chromium film became crystalline with a grain size ofless than 10...