Colonizing Bacillus in vanilla (Vanilla planifolia Andrews) beans is involved in glucovanillin hydrolysis and vanillin formation during conventional curing. The flavor profiles of vanilla beans under Bacillus-assisted curing were analyzed through gas chromatography-mass spectrometry, electronic nose, and quantitative sensory analysis. The flavor profiles were analytically compared among the van...

There has been a continual advent of improved technologies in dentistry. Among these are the material sciences of resin-based composites (RBCs). Since the introduction of light-cured RBCs, the problem of polymerization shrinkage and the methods used to overcome this have concerned clinicians and researchers. Types of curing light and modes of curing have been shown to affect the degree of polym...

Both the hardening process and formation of microstructure of concrete are significantly influenced by the curing condition. The capillary absorption of concrete is closely related to the structure and distribution of the pores within the material. This paper presents an experimental study on the influence of four curing conditions, i.e., standard curing, natural curing, water curing, and seale...

The effectiveness of two types of steady and flashing lights as escape hatch indicators for submerged helicopters was compared. Measurements were taken in moderately and highly turbid water. Response time was faster to the steady lights, and they were more accurately localized. Pairs of steady lights appeared to have some advantage over single lights, but this was not true for flashing lights. ...

As discussed in Part I, the type of curing light and curing mode impact the polymerization kinetics of resin-based composite (RBC) materials. Major changes in light-curing units and curing modes have occurred. The type of curing light and mode employed affects the polymerization shrinkage and associated stresses, microhardness, depth of cure, degree of conversion, and color change of RBCs. Thes...

We examine the influence of heterogeneous curing rates for a SIS model, used for malware spreading on the Internet, information dissemination in unreliable networks, and propagation of failures in networks. The topology structures considered are the regular graph which represents the homogenous network structures and the complete bi-partite graph which represents the hierarchical network struct...

High performance concrete (HPC) bridge decks are prone to premature cracking if movement is restrained. Internal curing (IC) can reduce shrinkage cracking in concrete structures, thus improving their performance and service life. However, there is very limited information available in the literature on the possible extension of service life due to internal curing. This paper addresses this ques...

Objective: It is believed that drivers play a crucial role in accidents. Paying attention to brake lights, a driver may find out about danger and react. Rear-end collision accidents refer to the part of the accidents due to driver inattention or slow reaction. The aim of this study was to determine the effect of dynamic flashing brake lights (7 Hz) on drivers' brake reaction time using the driv...

Dynamic illumination in real-time applications using OpenGL is still usually done with the classical light forms of point lights, directional lights and spot lights. For applications simulating real-world scenes, e.g. architectural planning, finding parameter sets for these simple lights to match real-world luminaires is required for realistic work. This paper describes a simple approach to pro...

EPIC's photonics technologies program manager Jérémy Picot-Clémente talks to Stephan Berlitz, head of Audi lighting development.