More than 80% of world energy is converted by combustion. Development of efficient next generation advanced engines by using alternative fuels and operating at extreme conditions is one of the most important solutions to increase energy sustainability. To realize the advanced engine design, the challenges in combustion research are therefore to advance fundamental understanding of combustion ch...

Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and n...

This paper simulates the density and temperature fields in the process of mixture formation with two combustion modes in a Diesel engine. The computational simulations and experiments show that in the normal combustion mode, the density and temperature of mixtures change greatly in the combusting sprays so that there are premixed combustion and diffusion combustion simultaneously, which results...

A noble low NOx combustion technology, based on partial oxidation combustion concept in a fuel rich combustion zone, is successfully applied in this research. The burner is designed such that a portion of fuel is heated and pre-vaporized in the furnace then injected into a fuel rich combustion zone so that a partial oxidation reaction occurs. The effects of equivalence ratio, thermal load, and ...

Since oxy-combustion is a relatively new technology, many problems associated with the behavior of coal in this novel combustion process still need to be solved. In particular, there is a lack of knowledge regarding the behavior of toxic trace elements, and there is a need to determine whether trace element distribution among the by-products and emissions to the environment, is comparable with ...

Combustion instabilities in gas turbine has been a major setback in the quest for efficient and clean combustion. Accurate characterisation and prediction of these disturbances is required to suppress them either at the design stage or in a close loop control when the system is in operation. The use of flame transfer functions has been a common approach in different literatures. Flame temperatu...

Control of diesel fuel injection is very important and has influence not only at engine operating conditions but also at emission of toxic gases as NOx, HC, and Particulate Matter (PM) are effect of combustion process. Directly observing of combustion process is very difficult, but implementation to injection control algorithm procedures based on additional sensors as knock sensor, cylinder pre...

Homogeneous charge compression ignition technology has exhibited high potential to reduce fuel consumption and NOx emissions over normal spark-ignition engines significantly. Optimized kinetic process technology is implemented to realize homogeneous charge compression ignition combustion in a port fuel injection gasoline engine. The combustion and emission characteristics are investigated with ...

CHAMBERS ACOUSTIC STABILITY Vladimir Bazarov Moscow Aviation Institute (State Technical University) 4, Volokolamskoe Shosse, Moscow 125080, RUSSIA E-mail: [email protected] Abstract Comparative analysis of the injector development history in order to eliminate acoustic instability in combustion chambers of LOX/kerosene big thrust engines both of gas generator and staged combustion cycle such as F-1, ...

Combustion instability of O2/kerosene, O2/kerosene/hydrogen, and O2/kerosene/hydrogen spray flame is numerically studied. The numerical results of combustion self-oscillation are consistent with the historical experiments. Hydrogen is helpful to stabilizing oxygen/hydrocarbon combustion. High gas injecting velocity of the coaxial injector would increase the combustion stability. Contrary to the...