Machining of brittle ceramics is a challenging task because the requirements on cutting tools are extremely high and quality machined surface strongly depends chosen process parameters. Typically, efficiency machining increases with depth cut or feed rate tool. However, for ceramics, this easily results in very rough surfaces even crack formation. The transition from smooth obtained small depth...

Cutting tool geometry should be very much considered in micro-cutting because it has a significant effect on the topography and accuracy of the machined surface, particularly considering the uncut chip thickness is comparable to the cutting edge radius. The objective of this paper was to clarify the influence of the mechanism of the cutting tool geometry on the surface topography in the micro-m...

Drilling is the most common machining operation and it forms the highest machining cost in many manufacturing activities including automotive engine production. The outcome of this operation depends upon many factors including utilization of proper cutting tool geometry, cutting tool material and the type of coating used to improve hardness and resistance to wear, and also cutting parameters. W...

In this paper, the profile of surfaces machined using end mills with flat and ball end tools in modeled. The real kinematics of the tool motion, the static deflection and the run out of the tool are included in the model. The cutting forces are calculated using a semi-empirical method based on orthogonal to oblique conversion of cutting coefficients. The thickness of the uncut chip is used as t...

Metal alloys have material properties that are very appealing for micro electro mechanical systems (MEMS), but present a challenge for process integration within a lithographic manufacturing sequence of the type used in the semiconductor industry. The batch-mode micro electrodischarge machining (μEDM) discussed here uses lithographically-fabricated electrode arrays with high density and high un...

Flexible blade cutting applied on thick layers of foam is very feasible for creating large sized physical models. The heated tool is set and moved in a circumferential tool motion along the front face of the layer. During these primary motions the cutting tool is positioned in order to ensure the best tool position and tool orientation for the cutting process. The adjustment of the tool positio...

Cutting fluids, usually in the form of a liquid, are applied to the chip formation zone in order to improve the cutting conditions. Cutting fluid can be expensive and represents a biological and environmental hazard that requires proper recycling and disposal, thus adding to the cost of the machining operation. For these reasons dry cutting or dry machining has become an increasingly important ...

The effects of cutting tool coating material and cutting speed on cutting forces and surface roughness were investigated by Taguchi experimental design. Main cutting force, Fz is considered as a criterion. The effects of machining parameters were investigated using Taguchi L18 orthogonal array. Optimal cutting conditions were determined using the signal-to-noise (S/N) ratio which is calculated ...

In micro-milling, cutting forces generate non-negligible tool deflection, which has a significant influence on the machining process and on workpiece accuracy. This paper investigates the tool deflection during micro-milling and its effect on cutting force and surface generation. The distribution of cutting forces acting on the tool is calculated with a mathematical model that considers tool el...