An Aluminum based in-situ alloy reinforced with Mg2Si and Si hard particles produced by casting Al-6Si-0.5Mg alloy. The microstructure, tensile properties and fracture behavior of the alloy were investigated and the results show that the Mg2Si and Si hard particles produced by precipitation hardening have great effects. The homogenized (24hr at 500 o C) and solutionized (2hr at 540 o C) cast al...

automotive and aerospace industries are required to light materials which have high properties. this causes to reduce production cost and fuel consumption. one of these advanced materials that have been attracted at these decades is particulate metal matrix nanocomposites. these materials have a combination of ductile matrix alloy properties and ceramic reinforcement nanoparticles. powder metal...

The fabrication of a composite membrane of nanoporous gold nanowires and anodic aluminum oxide (AAO) is demonstrated by the electrodeposition of Au-Ag alloy nanowires into an AAO membrane, followed by selective etching of silver from the alloy nanowires. This composite membrane is advantageous for flow-through type catalytic reactions. The morphology evolution of the nanoporous gold nanowires a...

In this study the Taguchi method, has been applied to optimize the heat treatment parameters for the corrosion resistance of AA6061 aluminum alloy. The experimental design consisted of four parameters (aging temperature, aging time, quenching environment and NaCl concentration), each containing three levels. Tafel polarization measurements were carried out to determine the corrosion resistance ...

Rice Husk Ash (RHA) of three different particle size ranges (50 – 75 μm), (75 – 100μm) and (100 – 150μm) in 3, 6, 9 and 12 % by weight was reinforced with the aluminium alloy using stir cast route. The microstructure and mechanical properties of the fabricated composites were analyzed. The results reveal that the tensile strength, compressive strength and hardness of the aluminum alloy composit...

The electrochemical behavior of 6063 aluminum alloy in ethylene glycol-water mixture was investigated by polarization curves and AC impedance measurements (EIS).  The results obtained from polarization curves showed that corrosion rate decreased with increasing ethylene glycol concentration. EIS data showed the decrease in the interface capacitance which caused by adsorption of ethylene glycol ...

Aluminum alloys of the 6xxx series which contain excess Si or Cu are well used for the automotive applications because of the high age-hardening response. The effect of addition of small amount of Sn on the two-step aging behavior in 1.2%Mg2Si-0.5%Si in excess alloy and 1.2%Mg2Si-0.7%Cu alloy was investigated by means of hardness measurement, differential scanning calorimetry, and transmission ...

In the paper, genetic algorithm is introduced in the study of network authority values of BP neural network, and a GA-NN algorithm is established. Based on this genetic algorithm-neural network method, a predictive model for fatigue performances of the pre-corroded aluminum alloys under a varied corrosion environmental spectrum was developed by means of training from the testing dada, and the f...

Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...

It has been proposed that with the appropriate models, instrumented indentation test (IIT) data can be reduced to yield the uniaxial stress–strain behavior of the test material. However, very little work has been done to directly compare the results from uniaxial tension and spherical indentation experiments. In this work, indentation and uniaxial tension experiments have been performed on the ...