In this study, the effect of a high-speed AP 7.62 bullet on Ti6Al4V, AISI 4340, Inconel-718, AlSi10Mg and Al 6061 - T6 materials at different impact angles were investigated by using finite element package software LS-DYNA 971. 4340 was taken as material 850 m/s speed for ballistic investigation. Angle obliquity against plates has been in range 0-80º. Simulations carried out 5 degrees increment...

Complex two-component peak of anelastic mechanical losses was observed in multicomponent substitutional austenitic alloys after prior plastic deformation. In AISI 316L, AISI 316LN, AISI 310 and AISI 304 austenitic stainless steels, this peak is situated in the wide range of temperature from 200 to 400K. Characteristics of the observed peak for different thermo-mechanical treatments were studied...

INTRODUCTION Contaminated sponges might lead to cross-contamination in kitchens since they can transfer microorganisms to surfaces where microorganisms can survive for hours or days and contaminate food. The main objective of this study was to evaluate the transfer and the survival of bacteria from kitchen sponges to surfaces of AISI 316 stainless steel and polyethylene. METHODOLOGY Twenty-fo...

behaviors of stress corrosion cracking (scc)in martensitic stainless steel(aisi 420) and low carbon austenitic stainless steel (aisi 316l) have been compared under different conditions of temperature, environment (mgcl2), and strain rate. the results show that decreasing strain rate has detrimental effect on mechanical properties of both steels, including their strength and ductility. fractogra...

High speed cutting is advantageous due to the reduced forces and power, increased energy savings, and overall improved productivity for discrete-part metal manufacturing. However, tool edge geometry and combined cutting conditions highly affects the performance of high speed cutting. In this study, mechanics of cutting with curvilinear (round and oval-like) edge preparation tools in the presenc...

National Institute of Standards and Technology, Boulder, Colorado 80303 Valid comparison of impact test energies reported by various organizations and over time depends on consistent performance of impact test machines. This paper investigates the influence of various specimen and test parameters on impact energies in the 1 J to 2 J range for both Charpy V-notch and Izod procedures, leading tow...

This paper deals with the study of various machining process and show the effect of different cutting parameters on the properties of material. There are several important factors in the product quality which are surface finish, cutting temperature, tool life and coolant quality. The use of coolant generally causes life of tools and it also maintains work piece surface properties without damage...