The syngas chemical looping (SCL) process developed at the Ohio State University can efficiently convert coal derived syngas into hydrogen with in-situ CO2 capture. In this novel process, two moving bed units are used to convert syngas into hydrogen through the assistance of an oxygen carrier particle. A third unit, an entrained bed combustor, is used to convey the oxygen carrier particles to c...

this paper reports a cfd modeling study to investigate the hydrogen-air mixture combustion in a micro scale chamber. nine species with nineteen reversible reactions were considered in the premixed combustion model. the effect of operational and geometrical conditions including; combustor size, wall conductivity, reactant flow rates and hydrogen feed splitting on combustion stability and outlet ...

This paper deals with the generation of new peaks in the pressure spectrum in controlled combustors in experimental investigations of active control of thermoacoustic instabilities. Typically, the reported experiments have demonstrated that the dominant thermoacoustic instability can be suppressed, but secondary peaks at different frequencies which were not excited in the uncontrolled combustor...

Improving the performance of flame holders has been a key focus research on ramjet combustors. The plasma actuator potential to improve ignition by manipulating flow field holder. In this study, plasma-actuated holder was designed. aim study is combustor applying discharge aerodynamic effects and were investigated. results demonstrated that induced jet direction surface arc perpendicular actuat...

During the last decade extensive research has been made at Lund University, Sweden, on a lean premix (prevaporize) combustion concept with burnt gas recirculation and a metallic flame holder. From this concept a new lean premixed natural gas combustion chamber with internal combustion gas recirculation (CGR) has been developed for the V160/SOLO 161 Stirling engines. This combustor has ultra-low...

Modern high speed aerospace propulsion relies on the development of scramjet engines significantly. Design of a supersonic combustor involves the potential problems of proper mixing, flame holding as well as flame stabilization within the very short period. Many techniques were introduced to overcome these problems, of which cavity flame holders has evolved as one of the prominent among them. T...

Numerical simulations of complex large-scale flow systems must capture a variety of physical phenomena in order to predict the flow accurately. Currently, many flow solvers are specialized to simulate one part of a flow system effectively, but are either inadequate or too expensive to be applied to a generic problem. As an example, the flow through a gas turbine can be considered. In the compre...

A Rocket Based Combined Cycle combustor model is tested at a ground direct connected rig to investigate the flame holding characteristics with a small rocket exhaust using liquid kerosene. The total temperature and the Mach number of the vitiated air flow, at exit of the nozzle are 1505 K and 2.6, respectively. The rocket base is embedded in a fuel injecting strut and mounted in the center of t...

A miniature combustor for converting organic samples into CO2 with application in carbon isotopic measurements has been manufactured and evaluated. The combustor was made of High-Temperature Co-fired Ceramic (HTCC) alumina green tapes. The device has a built-in screen printed heater and a temperature sensor made of platinum, co-sintered with the ceramic. A copper oxide oxygen supply was added t...

Combustion instabilities are a significant problem encountered in low NOx, premixed combustors used for ground based or aero-applications. Current capabilities to predict the conditions under which instabilities occur are immature, often resulting in the appearance of expensive and problematic instabilities late in the development stage of an engine. Consequently, there is significant interest ...