Blends of polypropylene (PP) and low-density polyethylene (LDPE) may contribute to make recycling more economically attractive. The aim of this work was to make PP/LDPE blends (0/100, 25/75, 50/50, 75/25 and 100/0 w/w) via injection molding carried out under various injection temperatures and to evaluate their tensile and impact properties. The blends yielded tensile stress–strain curves very d...

The transformation of fog at a non-visible water layer on a membrane of low-density polyethylene (LDPE) and ethylene-vinyl acetate (EVA) was evaluated. Nonionic surfactants of major demand in the polyolefin industry were studied. A kinetic study using a hot fog chamber showed that condensation is controlled by both the diffusion and permanency of the surfactant more than by the change of the su...

Injection moulding is one of the most popular polymer processing methods due to its high production rate as well as its ability to produce very intricate geometries at very cheaper cost and within few seconds. There are several flaws which occur while producing plastic parts by Injection moulding, like warpage, shrinkage, flash, sink marks etc. Shrinkage is one of the most critical problems whi...

Tribological properties of composites of low density polyethylene (LDPE) reinforced with 1, 5, 10, 20 wt% micrometric Boehmite (B) and/or preheated Boehmite (HB) powders were studied in combination with two silane coupling agents (SCAs): vinyltri(2-methoxyethoxy)silane (VTMES)-SCA 972 and 3-(trimethoxysilyl)-propylmethacrylate (3MPS)-SCA 989. When coupling agents are used, the samples not subje...

Composites of LDPE filled with different amounts of graphene nanoplatelets (GnP) were prepared in form of films by means of precoating technique and single screw melt-extrusion using two types of screws, compression and mixing. This manufacturing process imposes strong anisotropy on the sample’s morphology, in which the nanoplatelets become oriented along the extrusion direction. Such orientati...

Biocomposites of low-density polyethylene (LDPE) and polypropylene (PP) with 5–40wt% soy flour (SF) are produced by two-step single-screw extrusion (SSE) followed by solid-state shear pulverization (SSSP). The SSE-SSSP approach overcomes limitations with melt mixing, e.g poor SF dispersion and degradation, and limitations with single-step SSSP. Microscopy shows that SF is well dispersed in SSE-...

Cross-linked polyethylene (XLPE) is commonly used within high voltage cable insulation. It has improved thermal and mechanical resistance compared to normal low density polyethylene (LDPE). However, the cross-linking process may also vary the electrical characteristics of the material. This paper investigates changes in electrical properties of one type of LDPE before and after cross-linking. T...

A new passive sampler based on low-density polyethylene (LDPE) layflat tube filled with chrome shavings from tannery waste residues was evaluated to determine volatile organic compounds (VOCs) in indoor and outdoor areas. VOCs were directly determined by head space-gas chromatography-mass spectrometry (HS-GC-MS) without any pretreatment of the sampler and avoiding the use of solvents. Limit of ...

This paper presents the results of experimental and analytical studies mechanical thermal properties laterite composites mixed with reprocessed low-density polyethylene waste (LDPE), calcium phosphate (CaP) phosphogypsum wastes, biochar to form brick composites. Bricks mixtures 20% by volume LDPE, 15% CaP, gypsum were shown have excellent compressive strength, flexural fracture toughness. The 1...