ABSTRACT
 
 Two macro-roughness patterns namely spiral grooving and diamond knurling were performed on an AISI/SAE 1045 cylindrical steel bar. Al2O3 + 13 wt.-% TiO2 powder was deposited by utilizing a multi-pass torch. Microstructure, microhardness wear resistance analyzed. The presence of both γ-Al2O3 α-Al2O3 throughout the coating promoted partially melted un-melted particles; howev...

γ-Alumina is widely used as an oxide support in catalysis, and palladium nanoparticles supported by alumina represent one of the most frequently used dispersed metals. The surface sites of the catalysts are often probed via FTIR spectroscopy upon CO adsorption, which may result in the formation of surface carbonate species. We have examined this process in detail utilizing FTIR to monitor carbo...

The co-processing of an unconventional type of Jatropha bio-oil with petroleum distillates over mesoporous alumina-supported CoMo and NiMo sulfide catalysts (denoted CoMo/γ-Al2O3 and NiMo/γ-Al2O3) was studied. Either a stainless-steel high-pressure batch-type reactor or an up-flow fixed-bed reaction system was used under severe reaction conditions (330–350 ◦C and 5–7 MPa), similar to the condit...

Palladium nanoparticles were grown on sub-millimeter activated Al2O3 particle support by spraying H2PdCl4 solution evenly onto the support, followed with a thermal reduction under H2 atmosphere. Compared with its counterpart created by the conventional impregnation method, the Pd/Al2O3 catalyst created by the spray process could enrich the existence of active Pd nanoparticles on the surface of ...

The present study aims at developing A356/Al2O3(np) nano-composite with a novel and cost effective method for attaining homogeneous dispersion of Al2O3 nanoparticles in the Al matrix. In the current research, Al micro powders distributed on aluminum foil and then Al2O3 nanoparticles ultra-sounded in ethanol and sprayed on Al substrate. Subsequently, the sandwich foil was added to molten A356 du...

Methanobactin (Mb) is a copper-binding peptide that appears to function as an agent for copper sequestration and uptake in methanotrophs. Mb can also bind and reduce Au(III) to Au(0). In this paper, Au/Al2O3 catalysts prepared by a novel incipient wetness-Mb-mediated bioreduction method were used for glucose oxidation. The catalysts were characterized, and the analysis revealed that very small ...

An analysis of the steady mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3) and Titania (TiO2) are considered by usin...

The properties of CaCu3.1Ti4O12.1 [CC3.1TO] ceramics with the addition of Al2O3 nanoparticles, prepared via a solid-state reaction technique, were investigated. The nanoparticle additive was found to inhibit grain growth with the average grain size decreasing from approximately 7.5 μm for CC3.1TO to approximately 2.0 μm for the unmodified samples, while the Knoop hardness value was found to imp...

A simple and efficient synthetic protocol has been developed for the synthesis of 3-substituted-2H-1,4-benzothiazines by using a novel sulfonic acid functionalized nano-γ-Al2O3 catalyst, devoid of corrosive acidic, and basic reagents. The developed method has the advantages of good to excellent yields, short reaction times, operational simplicity, and a recyclable catalyst. The catalyst can be ...

The effect of heat source/sink on steady two-dimensional laminar MHD mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3...