Transmitted vibrations to the wrist and arm of a chainsaw operator: The effect of wood cutting process

Introduction: Due to the non-developed mechanization situation, chainsaw is a widely used tool in Iranian forests. This tool can trigger unwelcome disorders (e.g., white finger syndrome) due to the transmitted vibrations from its handle to the body members. Characterizing these vibrations can result in minimizing the intensity of these disorders. This study aims to investigate the effect of different hardwood species (Beech, Hornbeam, and Alder) on the vibrations transmitted to the wrist and arm. Material and Methods: Experiments are conducted during four operations including Beech-, Hornbeam-, and Alder-cross-cutting and without cutting as the control sample. Vibration accelerations in three directions of a local Cartesian coordinate system are measured at three points including chainsaw handle, operator's arm and wrist. Using the time and frequency spectra of vibration accelerations, root mean square (RMS), total vibration acceleration, total vibration transmissibility, and frequency-weighted vibration acceleration are calculated based on ISO 5349 (2001) and ISO 10819 (2013) standards. The calculated parameters were statistically analyzed in SAS. Results: The results showed that variations in wood species could significantly affect the RMS at all three points. The RMS magnitude decreases from handle towards the arm. Interestingly, a significant variation in vibration transmissibility is observed in different frequencies. This study confirms that body organs can damp the high-frequency vibrations better than the low frequency ones. Conclusion: Although the RMS for cutting operations is less than the control sample, frequency-weighted vibration acceleration and consequently the risk of white finger syndrome is higher in cutting regimes. Furthermore, some vibration accelerations (below 40 Hz for wrist and below 25 Hz for arm) are amplified during transmission despite significant damping in total vibrations.