Removal of parachlorophenol from the aquatic environment by recycled used tires as an adsorbent: Characterization, adsorption, and equilibrium studies
نویسندگان
چکیده مقاله:
Parachlorophenol has an extended usage in refineries, petrochemical industries, insecticide, and herbicide manufacturing industries. Tire a solid waste, which is disposed in large amounts each year, a large number of them in landfills can cause irreparable environmental impacts. Consequently lots of efforts were done to produce activated carbon from used tires. Activated carbon was made in laboratory conditions by using pyrolysis furnace. Scanning electron microscopy was used for determining structural characteristics of the activated carbon produced from recycled used tires and Brunauer, Emmett, and Teller isotherm was used to find out its special surface. The structure of produced activated carbon in this study has a special surface of 111.702 m2/g. The internal diameter of holes was 1.54 nm, and the total volume of them was 0.124 ml/g. The removal efficiency was reduced from 88.59% to 69.25% by changing the pH from 3 to 9. In addition, the efficiency was reduced from 88.59% to 75.95% when the primary concentration of parachlorophenol increased from 10 to 60 mg/L. On the other hand, changing the temperature from 10° C to 30° C increased it from 65.86% to 74.53%. Moreover, contact time had direct impacts on the removal efficiency. The results conform Freundlich isotherm (R2 = 0.9958). The efficiency of parachlorophenol removal would be decreased by increasing pH and concentration of the pollutant, and would be increased by adding temperature and contact time. As a conclusion, since the recycled tires are cheap, the produced activated carbon from them can be used as an effective and low-cost method for parachlorophenol removal from aqueous solutions.
منابع مشابه
Removal of Manganese(II) from Aqueous Solution by Chemically Activated Thuja Occidentalis Leaves Carbon (CATLC) as an Adsorbent: Adsorption Equilibrium and Kinetic Studies
In this research paper, chemically activated Thuja Occidentalis leaves carbon (CATLC) is used as an adsorbent for the expulsion of Mn(II) from aqueous solution. CATLC is characterized by FTIR, SEM and EDX. The effect of pH, initial Mn(II) concentration, CATLC dosage and contact time on the adsorption performance of CATLC for Mn(II) ions are examined by batch studies. The results reveal that CAT...
متن کاملEquilibrium Modeling and Kinetic Studies on the Adsorption of Basic Dye by a Low Cost Adsorbent
An agricultural waste and eco-friendly biosorbent i.e. rice husk has been used as a cheap adsorbentfor the removal of methylene blue dye from aqueous solutions. The physical properties of the developedadsorbent were characterized using FTIR. The study was realized using batch experiments. The effectsof contact time, pH, initial dye concentration, biosorbent dose and temperature were investigate...
متن کاملEquilibrium Isotherms and Kinetic Studies of Removal of Methylene Blue Dye by Adsorption onto Miswak Leaves as a Natural Adsorbent
In this research miswak leaves, agriculture wastes, available in large quantity in Saudi Arabia, was used as low-cost adsorbent for removing methylene blue (MB) dye. Equilibrium behavior of miswak leaves was investigated by performing batch adsorption experiments. The effects of [MB] 0, pH, contact time and adsorbent dose were evaluated. An alkaline pH (10.6) was favorable to the adsorption of ...
متن کاملequilibrium modeling and kinetic studies on the adsorption of basic dye by a low cost adsorbent
an agricultural waste and eco-friendly biosorbent i.e. rice husk has been used as a cheap adsorbentfor the removal of methylene blue dye from aqueous solutions. the physical properties of the developedadsorbent were characterized using ftir. the study was realized using batch experiments. the effectsof contact time, ph, initial dye concentration, biosorbent dose and temperature were investigate...
متن کاملEquilibrium Isotherm, Kinetic Modeling, Optimization, and Characterization Studies of Cadmium Adsorption by Surface-Engineered Escherichia coli
Background: Amongst the methods that remove heavy metals from environment, biosorption approaches have received increased attention because of their environmentally friendly and cost-effective feature, as well as their superior performances. Methods: In the present study, we investigated the ability of a surface-engineered Escherichia coli, carrying the cyanobacterial metallothionein on the cel...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ذخیره در منابع من قبلا به منابع من ذحیره شده{@ msg_add @}
عنوان ژورنال
دوره 2 شماره 1
صفحات 44- 53
تاریخ انتشار 2014-01-01
با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.
کلمات کلیدی
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023