Properties of Particleboard Made from UF with Low-formaldehyde (E1) (TECHNICAL NOTE)
نویسندگان
چکیده مقاله:
The objective of this study was to manufacture particleboard made from UF with low formaldehyde (E1) for use in indoor environments. The influence of UF in particles on the formaldehyde emission and its mechanical properties were investigated. The experimental results showed that the formaldehyde emission released decreased linearly with consumption UF-low formaldehyde- particle. Formaldehyde emission was below 0.3 mg/L when the weight percentage of UF particles was up to 60%. The formaldehyde emission from urea-formaldehyde resin-impregnated paper overlaid particleboard was 17% lower than UF ordinary (E2) for particleboard. Because, the bending strength, internal bonding strength decreased with increasing low-formaldehyde UF. However, the percentage thickness swelling of the particleboard decreased with increasing UF-low formaldehyde. In addition, there were significant positive relationships between the UF-low formaldehyde and the bending strength and internal bonding strength of the particleboard, which allowed evaluation of the properties of the particleboard made with UF-low formaldehyde
منابع مشابه
Characteristics of Particleboard Made from Sedar Chips and Wood Slabs (TECHNICAL NOTE)
This study was Characteristics of manufacture particleboard (PB) from sedar and wood slab of impregnated with UF. The chips were divided into coarse chips with dimensions of 2-4 mesh and fine chips of 30–60 mesh, urea formaldehyde (UF) resin solution at concentrations of 45 %, and 55% sprayed on these chips about 1 min until 10% to dry weight chips, they were dried under 5% moisture in a dram d...
متن کاملProperties of particleboard made from recycled CCA-treated wood
Recovery of chromated copper arsenate (CCA)-treated wood for reuse has been the focus of several international research groups due to the imminent disposal problem created when large quantities of CCA-treated wood ultimately come out of service. Bioleaching with Bacillus licheniformis CC01 and oxalic acid extraction are two methods known to remove significant quantities of metals from CCA-treat...
متن کاملEffect of Pretreatment of Raw Material on Properties of Particleboard Panels Made from Wheat Straw
The objective of this study was to evaluate properties of experimental particleboard panels manufactured from wheat straw that had been pretreated with acetic anhydride, soapy solution, hot water, or steam. Wheat straw particles were mixed with commercially manufactured wood particles at a ratio of 60%. Control straw particleboards with non-treated straw and wood particles were also produced. T...
متن کاملimproving textural and sensory characteristics of low-fat uf feta cheese made with fat replacers
saturated fat consumption increases the risk of both coronary and cancer diseases. therefore, fat reduction in uf-feta cheese (≈ 45% fdm) is favorable but, unfortunately, it has some negative effects on the texture and sensory characteristics of the cheese. in this research, response surface methodology was employed to study the probably improving effects of wpc80 (0-20 gr kg-1), lecithin (0-2 ...
متن کاملParticleboard quality characteristics of saline jose tall wheatgrass and chemical treatment effect.
The objective of this research was to characterize the qualities (mechanical properties and water resistance) of particleboard made from saline Jose Tall Wheatgrass (JTW), Agropyron elongatum. For the JTW particleboards made with 4% polymeric methane diphenyl diisocyanate (PMDI), the mechanical properties and water resistance improved with the increase of particleboard density from 0.71 to 0.75...
متن کاملMelamine-modified urea formaldehyde resin for bonding particleboards
For the development of a cost-effective melamine-modified urea formaldehyde resin (MUF), the study evaluated the effects of reaction pH and melamine content on resin properties and bond performance of the MUF resin adhesive systems. Eight resins, each with three replicates, were prepared in a factorial experiment that included two formulation variables: two reaction pHs (i.e., 4.5 and 8.0) and ...
متن کاملمنابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ذخیره در منابع من قبلا به منابع من ذحیره شده{@ msg_add @}
عنوان ژورنال
دوره 26 شماره 1
صفحات 45- 50
تاریخ انتشار 2013-01-01
با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.
کلمات کلیدی
میزبانی شده توسط پلتفرم ابری doprax.com
copyright © 2015-2023