Preparation and characterization of nanostructured S and Fe co-doped TiO2 thin film by ultrasonic-assisted spray pyrolysis method

نویسندگان

  • Javad Yekrang Department of Textile Engineering, University of Bonab, Bonab, Iran.
چکیده مقاله:

Nanostructured TiO2 and S and Fe co-doped TiO2 thin films with high transparency were prepared on glass substrate through ultrasonic-assisted spray pyrolysis technique. The effects of doping on morphological, optical and structural properties of TiO2 were studied by scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), photoluminescence spectroscopy, Raman spectroscopy, and UV-visible absorption spectroscopy techniques. Because of the high uniformity and monodispersity of the prepared thin films, they have high visible light transparency. All of the prepared thin films have anatase crystal structure, however, introduction of the dopants, especially S dopant, in the lattice of TiO2 creates some structural defects in the TiO2. Because of the presence of defects as charge trapping center in the structure of the doped TiO2samples, these thin films have lower electron–hole recombination rate than undoped TiO2. Furthermore, simultaneous doping of S and Fe considerably narrows the band gap energy of TiO2.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Preparation and growth of SnS thin film deposited by spray pyrolysis technique

In  this paper  thin  films of  tin sulfide (SnS) were deposited on  the glass substrates using spray pyrolysis method with the substrate temperatures in the range of 400–600℃, keeping the other deposition parameters constant. In  this work  the characteristic of SnS  thin  films  investigated. The XRD pattern and optical transmittance of thin films also are discussed. With the change in concen...

متن کامل

Ultrasonic–Assisted Co–Precipitation Method of Preparation of Nanocomposites in The Al2O3–TiO2–ZrO2 System: Characterization and Microsturcture

Recently, the Al2O3–TiO2–ZrO2 system has found valuable applications, particularly, as a support for NOx storage–reduction (NSR) catalysts. Nanocomposite powders were prepared from the co-precipitation method in inorganic precursors. The behaviors of mixed oxide nanoparticles under ultrasonic irradiation, such as dispersion, and crushing were studied. Phase transformations, crystallite size, an...

متن کامل

Deposition and characterization of SnO2:Sb thin films fabricated by the spray pyrolysis method

In this study, thin films of transparent semiconductor tin oxide doped with antimony impurities on the glass substrates with different concentrations of antimony that have been prepared using spray pyrolysis method. The effects of different concentration of antimony on the structural, optical, and electrical properties of the thin films were investigated. Prepared layers were characterized by X...

متن کامل

preparation and characterization of new co-fe and fe-mn nano catalysts using resol phenolic resin and response surface methodology study for fischer-tropsch synthesis

کاتالیزورهای co-fe-resol/sio2و fe-mn-resol/sio2 با استفاده از روش ساده و ارزان قیمت همرسوبی تهیه شدند. از رزین پلیمری resol در فرآیند تهیه کاتالیزور استفاده شد.

Structural and electrical properties of In-doped vanadium oxide thin films prepared by spray pyrolysis

The In-doped vanadium pentoxide nanostructures with different doping levels including 0, 10, 20 and 30 at.% were prepared by the spray pyrolysis technique. The prepared thin films were characterized by the x-ray diffraction (XRD) and scanning electron microscopy (SEM). The XRD results revealed that the films were crystalline in tetragonal phase. Increasing the In-doping level made the structure...

متن کامل

preparation and growth of sns thin film deposited by spray pyrolysis technique

in  this paper  thin  films of  tin sulfide (sns) were deposited on  the glass substrates using spray pyrolysis method with the substrate temperatures in the range of 400–600℃, keeping the other deposition parameters constant. in  this work  the characteristic of sns  thin  films  investigated. the xrd pattern and optical transmittance of thin films also are discussed. with the change in concen...

متن کامل

منابع من

با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ذخیره در منابع من قبلا به منابع من ذحیره شده

{@ msg_add @}


عنوان ژورنال

دوره 8  شماره 3

صفحات  251- 258

تاریخ انتشار 2018-07-01

با دنبال کردن یک ژورنال هنگامی که شماره جدید این ژورنال منتشر می شود به شما از طریق ایمیل اطلاع داده می شود.

میزبانی شده توسط پلتفرم ابری doprax.com

copyright © 2015-2023